- You are currently viewing DISCO3.CO.UK as a guest - Register to take part or Log In
Advanced Factors
Site Sponsor
Member Since: 27 Nov 2012
Location: Southampton
Posts: 2650
|
jasminjamil
This is a common problem on this vehicle, a full oil flush may help but if you have experienced bad judder for a long time then you may well end up having a new Torque Converter or perhaps even a new transmission.
The judder is likely caused by the Torque Converter not locking up.
Adding of the Dr Tranny or changing the oil is often done too late, despite Land Rover having said the box is sealed for life you could prolong the life by changing the oil earlier.
The motor industry has long said that oil changes can cause failure, this is not quite true a transmission that fails after an oil change was one about to fail anyway, ignoring your problem will not make it go away. Try the flush but be prepared to invest in new parts if it does not help you. Paul Redding
+44 (0)23 8052 2774
Order Parts Online at www.advancedfactors.co.uk
|
 5th Mar 2014 10:37 am |
|
|
jimbo1981
Member Since: 25 Oct 2013
Location: Harare
Posts: 110
  
|
I cant imagine that a megaflush would damage the valve body? The machinery is simply pumping ATF through your system at the same pressure that it normally circulates at.
Interested to know if a megaflush (and pan/filter change) fixes your problem - I have read a lot that once Dr Tranny has been used, if the judder returns, its time for a hardware replacement. 2005 Discovery 3 2.7 TDV6 HSE (Auto)
|
| 5th Mar 2014 10:37 am |
|
|
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20855
 
|
There has been a lot of discussion about the Autobox oil in the past few weeks.
LR state 150k miles
ZF (who build the gearbox) state 75k miles
However, there are some places who have tested the oil, and say that it starts to degrade around the 60k mile mark My D3 Build Thread
TDV8 Retrofit Build Thread
|
| 5th Mar 2014 10:42 am |
|
|
jasminjamil
Member Since: 05 Jul 2013
Location: Penang
Posts: 9
 
|
Boringoldgit wrote:jasminjamil
This is a common problem on this vehicle, a full oil flush may help but if you have experienced bad judder for a long time then you may well end up having a new Torque Converter or perhaps even a new transmission.
The judder is likely caused by the Torque Converter not locking up.
Adding of the Dr Tranny or changing the oil is often done too late, despite Land Rover having said the box is sealed for life you could prolong the life by changing the oil earlier.
The motor industry has long said that oil changes can cause failure, this is not quite true a transmission that fails after an oil change was one about to fail anyway, ignoring your problem will not make it go away. Try the flush but be prepared to invest in new parts if it does not help you.
Hi Steve,
Thank you for your respond. Changing transmission oil is like prevention and additive in this case, in for temporary relief.
The judder only occur when the I've driven them for at least 50km. That will get the transmission temperature going before the symptom occur. Bear in mind that the ambient temperature here is like 40 degrees to 45 degrees celcius.
I believe my 2003 E66 uses the same 6HP26, but after 220k km it is still running perfectly. I have changed transmission oil once so far. (I think i should change them again on the next oil change)
Could this mean the cooling system in the BMW is more effective than the LR3?
|
| 5th Mar 2014 1:34 pm |
|
|
jasminjamil
Member Since: 05 Jul 2013
Location: Penang
Posts: 9
|
jimbo1981 wrote:I cant imagine that a megaflush would damage the valve body? The machinery is simply pumping ATF through your system at the same pressure that it normally circulates at.
Interested to know if a megaflush (and pan/filter change) fixes your problem - I have read a lot that once Dr Tranny has been used, if the judder returns, its time for a hardware replacement.
Hi Jimbo,
Thank you so much for your reply. I think it left me no choice but to insist the mechanic to do a full mega flush.
Need advice on the steps. No matter which way I rearrange them, still doesn't sound right.
1. Drain out existing oil via sump.
2. Remove sump / filter / pan
3. Put in new pan
4. Top my new oil until spill out from the filler
5. Run engine and keep topping up until overflow
6. Close filler.
7. Connect oil cooler to mega flush machine
8. Run machine until drained out oil is as good as the new oil.
Confused.
|
| 5th Mar 2014 1:43 pm |
|
|
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20855
|
While the filters tend not to get clogged up, it seems a shame to run old, dirty oil through a new filter...
At the same time though, it seems a waste to drop clean oil to change the filter...
Can't win either way  My D3 Build Thread
TDV8 Retrofit Build Thread
|
| 5th Mar 2014 1:49 pm |
|
|
jasminjamil
Member Since: 05 Jul 2013
Location: Penang
Posts: 9
|
By the way, in case if I need to buy a good rebuilt gearbox or torque converter, could you be kind to let me know where to get it?
Many thanks.
|
| 5th Mar 2014 2:22 pm |
|
|
Whooooooosh
Member Since: 17 Feb 2014
Location: Southampton
Posts: 36
|
Hi,
I had a few problems with the car jumping out of gear and over revving. Also the gear selector was very stiff on my 2006 D3 with 118K on the clock.
Today I had the Auto box lever pivot replaced and a Wynn's transmission flush finished off with a dose of Dr Tranny.
The ATF that came out was black and after about 12 litres of new fluid was drawn through the system what came out was lovely and golden. I likened it to the colour of ground nut oil.
After the treatment the gears engaged faultlessly and the over revving had ceased.
Highly recommended.
|
| 5th Mar 2014 5:52 pm |
|
|
geoff.
Member Since: 24 Jan 2010
Location: West kent
Posts: 8531
|
good to meet you today and the first car I've been into with absolutely no faults on the transmission 
|
| 5th Mar 2014 7:35 pm |
|
|
L1RNJ
Member Since: 25 Mar 2014
Location: Birmingham
Posts: 10
|
Message for Geoff, the hero mega flusher.
do you stretch as far as south Birmingham? Im in need of a flush... well my car is.
|
| 26th Mar 2014 12:07 am |
|
|
gensetsteve
Member Since: 01 Jan 2014
Location: hampshire
Posts: 340
 
|
Could the judder/ glazing of the clutch bands be something to do with the very high quality oil now used. Does it protect the bearings better but over protect the cluches. Does anyone towing hard get these problems. Could towing possibly keep these problems at bay until everything flys out the side.  Geoff I need to save the pennies and get you into flush mine towed it up to 68k now done at least 2000 miles in the last 7 days. D4
|
| 26th Mar 2014 8:57 pm |
|
|
waterbuoy
Member Since: 26 Oct 2013
Location: Argyll
Posts: 2929
|
I assume that you have seen this thread Steve?
http://www.disco3.co.uk/forum/topic108824....o+flushing
Whilst I don't tow asmuch as you, my vehicle is worked quite hard
Yours may JUST be in range Currently 2009 Disco 3 SE, 2013 MY D4 HSE and 2016 D4 SE
Previously:
TD5 Defender 110 CSW (230k miles)
300TDi Disco 1 (289k)
4 RR Classics (300-350k each, 2 manual, 2 auto)
110 V8 CSW (220k)
S3 109 hi cap pickup (ex RN)
S2A 88 Safari SW with lpg conversion (bloody lethal)
|
| 26th Mar 2014 9:01 pm |
|
|
gensetsteve
Member Since: 01 Jan 2014
Location: hampshire
Posts: 340
|
yes thanks read it through about a week ago. Next big thing to fail will get repaired then it gets sold. Just dont need the pain will be another Amazon on the drive . If I spend more than £500 every 10,000 miles on any vehicle apart from servicing its binned. I may get a down rated twin wheel iveco van next. D4
|
| 27th Mar 2014 5:25 am |
|
|
TdV6Pete
Member Since: 10 Aug 2012
Location: Rutland
Posts: 415
|
Where do you fill the gearbox oil up from? I want to a) check the oil level, and then b) add some more if its low.
Found lots of info on people doing it, but no one says HOW and WHERE to fill it up (inc pictures would be ideal)
Cheers! 2inch Lift, 33inch Cooper STTs, Wheel Spacers, Hidden Champion 9000lbs Winch with recovery points, Full Underbody Protection including Rear Bumper Guard, Rock Sliders, Snorkel, 4x4 screen enabled and Sat Nav on the move (thanks to Bodsy), Discreet LED roof lights, LED work light, BAS Re-map and EGR's blanked, V8 Brake upgrade with Grooved, Drilled and Slotted Brakes, Halo Fog Lamps, Roof Rack, 240V Inverter, CB radio and finally a Swing away wheel carrier with Hi-Lift mount...
|
| 27th Mar 2014 9:32 am |
|
|
bsm
Member Since: 14 May 2012
Location: Ellikom
Posts: 232
 
|
http://www.disco3.co.uk/forum/topic108447.html
First picture, red arrow. 2017-...: Disco II Td5 auto, 1999, BAS remap, HD TC and auto box Ashcroft, Allisport IC, ACE, 2" lift only coils, BF goodrich KM2 265/70R17, FF front and rear bumper, TF steering guard and tree sliders, nanocom.
2013-2017: Disco 3 TDV6 HSE aut. of 2008, Britpart treesliders, IIDTool, RLD sump guard, BFG KM2 265/70R17, adj. rods, BAS remap + EGRs blanked, silicon IC hoses.
2010-2013: Disco II Td5 of 2000, ACE, front Bearmach HD coils, rear SLS, GG AT2
|
| 27th Mar 2014 2:50 pm |
|
|
|
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
|
|
