Flack
Member Since: 06 Sep 2006
Location: Preston Lancashire
Posts: 6307
  
|
Ade
That's how mine fires up using GSM unit it starts off slow then runs up to full speed in two or three stages.
Flack 
Ade wrote:I've had the bits and pieces lying around for a while now, so decided to give it a go
Didn't take long, and have now got all the bits fitted
Tested by pressing the manual buton on the timer, and the FBH fires up fine, not had chance to configure the GSM unit as yet, will try one night after work
MY only worry was that the FBH seems to have different (speed?) settings. When I pressed the flame button it turned on, and then if I pressed it again, it went up a level, and then again, until pressing it for a forth time, it would turn off
Is this operating correctly?
If it is, at what speed will it operate when switched by the GSM unit? The lowest/first setting I assume?
Is everyone elses like this?
Thanks
Ade
|
 20th Jun 2010 10:32 pm |
|
|
CJM625
Member Since: 21 Jun 2010
Location: Cheshire
Posts: 258
 
|
Hi,
I've bought a telestart that I'd like to wire into my FBH, I've tried to follow the link on at the begining of this topic regarding non GSm fitting but it seems to be dead?
Dead link: http://www.disco3.co.uk/forum/topic15454.html)
Can anyone help?
|
| 13th Jul 2010 9:27 am |
|
|
|
|
CJM625
Member Since: 21 Jun 2010
Location: Cheshire
Posts: 258
|
My car has a RED wire going into PIN 2 which I've cut  2015 BMW i3 REX
2014 Golf GTD DSG
|
| 13th Jul 2010 8:28 pm |
|
|
ronp
Member Since: 29 Nov 2006
Location: North Yorkshire
Posts: 15263
  
|
After the power has been disconnected I need to re-set my webasto timer [model 1533].
Never done this yet and thing is, I don't have the instructions.
How do I re-set it?
Is it just a simple press of the 'set' button? ...... always on the road less travelled 🚧
|
| 28th Sep 2010 11:34 am |
|
|
|
|
ronp
Member Since: 29 Nov 2006
Location: North Yorkshire
Posts: 15263
|
Thanks Adrian
D3 just back from service by dealer.
Will have a good read and then a little fettle later. 
...... always on the road less travelled 🚧
|
| 28th Sep 2010 3:21 pm |
|
|
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14372
|
Do you use the timer on it ? ..i dont ...so never have to reset any thing after battery disconnect  G4 Gone ...but not forgotten
|
| 28th Sep 2010 4:07 pm |
|
|
ronp
Member Since: 29 Nov 2006
Location: North Yorkshire
Posts: 15263
|
No don't use the timer, just phone to start it.
Pete [BAS] fitted it and found that when power was disconnected that it needed re-setting.
Said this wasn't the norm and probably now on the newer models.
[Bought and had it fitted around Feb] ...... always on the road less travelled 🚧
|
| 28th Sep 2010 4:15 pm |
|
|
Trackman
Member Since: 16 Apr 2010
Location: Glasgow
Posts: 430
|
Only need to "reset" it if you want the correct time on it or change the Run time e.g. from 30 mins to 20min.
Well, this applies to the one I have 
Ian.
|
| 28th Sep 2010 9:50 pm |
|
|
ronp
Member Since: 29 Nov 2006
Location: North Yorkshire
Posts: 15263
|
Phoned it last night and it fired up - without me touching it.
But it didn't fire up a few weeks ago - maybe it wasn't cold enough.
 ...... always on the road less travelled 🚧
|
| 29th Sep 2010 8:07 am |
|
|
Trackman
Member Since: 16 Apr 2010
Location: Glasgow
Posts: 430
|
romp,
don't understand that one as the timer talks directly to the Webasto and is not under the temperature contol of the car.
When I installed mine it was in the summer and I can fire it up at any temperature.
Put it down to electronics not playing.
Ian.
|
| 29th Sep 2010 10:13 am |
|
|
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14372
|
As above ..if its on remote or phone ..it makes no odds what the temp is ...it will fire up G4 Gone ...but not forgotten
|
| 29th Sep 2010 10:20 am |
|
|
blue meanie
D3 Decade
Member Since: 04 Aug 2005
Location: Newbury
Posts: 6861
|
I test fired mine a couple of weeks ago before it went in for it's service and it took two goes, so probably just down to not being used for a few months, also on the version of 1533 I have if the power is off to it it needs a couple of presses of the set button to put it into a mode ready to be used. and theeeeennn......???
|
| 29th Sep 2010 10:31 am |
|
|
ronp
Member Since: 29 Nov 2006
Location: North Yorkshire
Posts: 15263
|
That answer will do for me BM ...... always on the road less travelled 🚧
|
| 29th Sep 2010 10:44 am |
|
|
