discoBizz
Member Since: 20 Sep 2008
Location: Manchester
Posts: 1416
  
|
Can we confirm that if no oil is present in the servo, vacuum pump or anywhere it shouldn't be, then all the recall states as action is to replace the brake booster vacuum line with the upgraded part? Not too clear reading the notice...
This is what the local LR dealer did on mine as there was no oil anywhere  apparently 
|
 1st Feb 2010 3:48 pm |
|
|
Gaza
Member Since: 08 Jan 2009
Location: At the foot of the Lammermuirs
Posts: 448
 
|
Gaza wrote:My car is in a Westover LR today for a few bits to be looked at under warranty. I asked about the brake servo recall and was told I was not affected. I find this strange as according to the bulletin all vehicles in the range LA367110 – LA513325 need to have it done and my VIN ends 4901XX. That certainly seems to be in the range.
After calling LR CS today it seems the job was done at Stratstones in Edinburgh after the car was recovered following a height sensor failure. They never mentioned it to me when I collected it. LR CS say it is policy to do all recalls as soon as the car is in a LR dealer.
|
| 1st Feb 2010 9:53 pm |
|
|
sitticheep
Member Since: 10 Sep 2009
Location: Thailand
Posts: 11
|
Hi, I live in Thailand and my car VIN was not in the range (LA3275xx) I call dealer to ask about recall as my Disco got the lost vacumm assist. I open up the plastic cover to check for oil and YES!! i found an oil in vacumm hose. the issue is Dealer refuse to claim as not in recall range. What should I do? Does anyone ever had chance with LR like my case?
|
| 2nd Feb 2010 8:20 am |
|
|
jimbo81
Member Since: 16 Mar 2008
Location: 1st in the PNC 2013
Posts: 191
|
Just had this very issue with intermitant massive brake fade on my '55' reg!
Took it into the dealers yesterday, said that i had done some research (good old D3.co.uk!  )and knew there was a recall but mine was out of range.. and they first replaced the master cylinder, kept it over night for one of their Tech guys to take it home to 'make sure' it was ok, which is wasn't, so replace the brake servo today.
Got a phone call to say ot was all done and got told that they had contacted land Rover and despite mine being out of the range of the recall, they replaced it all under the recall work!!
Very happy!!  especially as my D3's got 103K on the clock and is 4 years old!!
So, if anyone else has same problem, definatly push for it being done under the recall work! You only live once, but if you work it right, once is enough.
|
| 25th Feb 2010 7:05 pm |
|
|
TazDaz
Member Since: 07 May 2007
Location: South East Essex
Posts: 2858
|
just had mine inspected and dealer (Beadles LR) have replaced the servo and the vacuum pipe line
It's made a lot of difference to the braking ability !
|
| 25th Feb 2010 7:44 pm |
|
|
sarumlight
Member Since: 06 Nov 2008
Location: Off the Plain
Posts: 1592
|
Just a reminder that if this happens and you can think quickly enough, pulling on the EPB switch (handbrake) will stop the D3 safely using the ABS system, even if there is no servo assistance at all.
|
| 25th Feb 2010 8:04 pm |
|
|
disco3nw
Member Since: 24 Jan 2010
Location: nr stafford
Posts: 2
|
Hi All -- my 07 disco 3 in at stealers on Tuesday last for recall. Pipe replaced and new servo fitted.
Before going in brakes were fine, pedal positive (as its been from new). When driving home I noticed pedal was 'spongey' and if pumped became hard..... but when stationary pedal can be pushed virtually to floor! Also  pedal now returns very slowly when released.
Called stealer who collected yesterday & later returned it with a 'no problems - everything's OK'
I tried it out and complained like hell as it was exactly the same as before!
They collected it again today & say they've fitted a new master cylinder.... but guess what? ..... no improvement whatsoever. Stealer says nothing more they can do & its exactly the same pedal feel & floor travel as on 2 new Discos which they tried.
Any body got any suggestions please?
|
| 26th Feb 2010 8:43 pm |
|
|
malky
Member Since: 27 Dec 2007
Location: Sydney
Posts: 59
  
|
Just had to have mine done
VIN # just under range in recall
cost $1000 plus including the new trombone plumbing
advised to complain formally
big time safety issue IMHO
+======
|[___][__\___
|...-........-.......| '0|
+--(O)-------(O)--+
TDI 300 and D3 MY06 SE and Shiraz D4 MY11 with Faerie Lites
|
| 1st Mar 2010 7:33 am |
|
|
KevB
Member Since: 21 May 2009
Location: Sunderland
Posts: 108
|
I know the mail has been backed up due to the weather but I just got my recall letter for this problem today.
|
| 24th Dec 2010 3:40 pm |
|
|
Rob H
Member Since: 12 Jul 2007
Location: North East Scotland
Posts: 87
|
Only just received the letter from LR this week. With SAFETY RECALL printed in red on the outside of the envelope. We had to quote "Recall Programme P017" when making the appointment at the dealers.
So this is not a new recall then, or is it?
Anyone know?
Cheers,
Rob 2005 TDV6 base model 7-seater manual
|
| 22nd Jan 2011 10:41 am |
|
|
olly
Member Since: 01 Jan 2010
Location: Co. Durham
Posts: 26
|
Hi all, just got a recall letter for mine this morning which says all 05/06 model years, my chassis number starts 364 so is earlier than all previous numbers
|
| 25th Jan 2011 1:14 pm |
|
|
Nasher
Member Since: 07 Mar 2009
Location: Clanfield, North of Pompey - UK
Posts: 2813
|
I received my letter today, so will be booking it in soon to have it done.
Like Olly it states 05/06 models.
Nasher. Heaven doesn't want me, and hell is afraid I'll take over.
|
| 25th Jan 2011 7:43 pm |
|
|
Ade
Member Since: 26 Nov 2008
Location: West Lothian
Posts: 950
|
Nasher wrote:I received my letter today, so will be booking it in soon to have it done.
Like Olly it states 05/06 models.
Nasher.
I received a same letter yesterday
Only trouble is after nearly having a bad accident last year I paid to have mine looked at, and paid for a new brake booster, master cylinder, revised pipework/valve, and replacement of brake fluid
Do you think I could claim the money back? Will try to phone LR today
|
| 2nd Feb 2011 9:02 am |
|
|
GrenobleLandy
Member Since: 04 Mar 2009
Location: Grenoble
Posts: 116
|
Just got the recall here in France. Mine says MY2006-09... TDV6 HSE AUTO
Defender 90 CSW
|
| 14th Feb 2011 4:25 pm |
|
|
Bonehead
Member Since: 14 Nov 2010
Location: South Yorks
Posts: 137
|
had mine done today, 05 HSE.
They ended up changing the servo too. Not impressed with the extra pipework under the bonnet though 
|
| 14th Feb 2011 10:11 pm |
|
|
