Member Since: 09 Feb 2010
Location: Moelv
Posts: 9
disco1983 wrote:
Ok so I have tries the sys test again, and still I get the flashing econ light but no more lights once the ignition has been selected off then back on. I have already checked blower elec connection, which is ok. Scratching my head now !!!
I have the same symptoms on my car. Did you manage to sort it out?!D3 MY2005 TDV6 HSE PP
8th Apr 2013 1:41 pm
3280busby
Member Since: 10 Feb 2014
Location: Larkhill
Posts: 2
Fan blower
I too have the same problem! It started being an intermittent fan sounded like it was stalling, now it has packed in all together! I have tried the relay which appears to be fine as do the fuses!?
I've now removed the fan and tried to run it from a 12v Bty to test it to no joy??
However when I run the volt meter over the fan power plug there is no reading also no reading from the power that goes into the socket to the control module??
Any help massively appreciated thank you!!!
10th Feb 2014 8:17 pm
tomtom86
Member Since: 09 Mar 2013
Location: Here and there
Posts: 590
Have you checked the heater resistor? If you remove the motor and put power to it and it still doesn't work then it can only mean the motor is faulty.
The link below is to an album of mine that has within a number of heater and air conditioner files.
In particular there are pdf's explaining the operation of the rear heating / AC system as well as wiring diagrams for both front and rear systems.
http://www.disco3.co.uk/gallery/thumbnails.php?album=303002005 LR3 HSE 4.4L AJ-V8 petrol; Traxide Dual Battery; PIAA 2500K Yellow Ion H11 Fog Light bulbs; CounterAct LT-2 Capacitive Corrosion control; LLumar AIR80 Blue clear Infra Red blocking side window film; Liftgate manual release; Schrader Valve "air in" mod to OEM air suspension reservoir tank; Akebono ceramic pads; OEM solid vented discs; LR4 design hitch receiver; Wiggs D4 MOST bluetooth module; Clock on the Dash; 3 Flash signal light mod; Backup Camera; 2015/16 Nav Data update.
11th Feb 2014 12:42 am
3280busby
Member Since: 10 Feb 2014
Location: Larkhill
Posts: 2
Guy,s
Thanks for the help!! It was 12v I put through the pan to test it dose any one know if that would of been enough??
Thanks adds
Yes, to test the operation of the fan, all you will need is two wires to the fan, one being 12 VDC and the other being a ground wire.
Getting a good ground connection can be more difficult than getting 12 volt DC electricity.
The fan blades should rotate if the fan is OK and you have both the 12 VDC and a good ground connection.2005 LR3 HSE 4.4L AJ-V8 petrol; Traxide Dual Battery; PIAA 2500K Yellow Ion H11 Fog Light bulbs; CounterAct LT-2 Capacitive Corrosion control; LLumar AIR80 Blue clear Infra Red blocking side window film; Liftgate manual release; Schrader Valve "air in" mod to OEM air suspension reservoir tank; Akebono ceramic pads; OEM solid vented discs; LR4 design hitch receiver; Wiggs D4 MOST bluetooth module; Clock on the Dash; 3 Flash signal light mod; Backup Camera; 2015/16 Nav Data update.
11th Feb 2014 3:28 pm
barce1987
Member Since: 18 Jun 2014
Location: barnsley
Posts: 33
heater fault
When I get in my disco3 and put blowers on they work for about 7 mins then stop . So I turn lights off on panel . Turn it bk on nothing happens . Leave it for a good 10-15 mins turn them on and it works for about 5 mins then off again what could this be any ideas. Thanks dean
18th Jun 2014 7:29 am
crazy
Member Since: 27 Jan 2008
Location: Near Milan
Posts: 1852
R16 relay is the first option.
My system worked randomly; changed the relay and everything came back ok.
CiaoLandy lover
Membro del Club
18th Jun 2014 9:24 am
barce1987
Member Since: 18 Jun 2014
Location: barnsley
Posts: 33
Where do I find the relay to replace it
18th Jun 2014 10:28 am
crazy
Member Since: 27 Jan 2008
Location: Near Milan
Posts: 1852
In the fuse box in the engine compartment; on the lid of the box shows the relays with numbersLandy lover
Membro del Club
18th Jun 2014 10:49 am
barce1987
Member Since: 18 Jun 2014
Location: barnsley
Posts: 33
Thank u very much pal
18th Jun 2014 12:14 pm
barce1987
Member Since: 18 Jun 2014
Location: barnsley
Posts: 33
hello crazy
i took the relay out to see if there was owt wrong with it and put it bk in and they stopped working all together. so ive changed the relay and 40amp fuse too and still nothing at all .
do u no what else it could be ?
thanks dean
19th Jun 2014 4:34 pm
crazy
Member Since: 27 Jan 2008
Location: Near Milan
Posts: 1852
I would not know; someone more knowledgeable than me will certainly respond.
The relay has been replaced or just taken off and put back?Landy lover
Membro del Club
20th Jun 2014 7:06 am
barce1987
Member Since: 18 Jun 2014
Location: barnsley
Posts: 33
i took it off and back on to start with then it stopped working altogether . so ive replaced it and still nothing
20th Jun 2014 7:32 am
barce1987
Member Since: 18 Jun 2014
Location: barnsley
Posts: 33
hello
hello my heater is still playing up . ive tried a new fan and a new heater control unit . ive tried a new relay too . i also have a little video of whats happening i will try get it on youtube and share link
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum