Member Since: 12 Aug 2011
Location: West Sussex
Posts: 1278
Socket for crankshaft bolt?
I need a good quality 21mm 3/4 drive socket to remove the D3 crankshaft bolt. I could not get enough leaverage with my 1/2 drive, so put on my 1/2 to 3/4 adaptor, and promptly sheared it. It's tight.
What make do folks use. I can't seem to find a Snap On one.
Any ideas on where to get a good quality one from?
Thanks
John
17th May 2014 5:10 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20787
Member Since: 10 Sep 2012
Location: Northampton
Posts: 1034
I have the Halfords 3/4" drive professional set so used that with a 40" breaker bar.GAP IID Pro Multi Vehicle Defender L316 2007-2015 - Discovery 3 - Discovery 4 - Discovery Sport L550 - Freelander 2 - Range Rover Evoque L538 - Range Rover L322 - Range Rover L405 - Range Rover Sport L320 - Range Rover Sport L494 Electrical Fault Diagnostics
17th May 2014 6:17 pm
BigAl
Member Since: 12 Mar 2012
Location: Bristol
Posts: 144
If you got any old sockets 7/16 whitworth is also a perfect fit.
17th May 2014 6:49 pm
geoff.
Member Since: 24 Jan 2010
Location: West kent
Posts: 8531
really
17th May 2014 8:17 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20787
Member Since: 22 Aug 2013
Location: Out in the world
Posts: 967
"Hello? Victoria and Albert Museum? Would you mind checking to see if any of your exhibits are missing?"
I used a 21mm 1/2" impact socket, with an 18" breaker bar and a 2m galvanised pipe. No problem whatsoever.
17th May 2014 11:08 pm
John P
Member Since: 12 Aug 2011
Location: West Sussex
Posts: 1278
I tried with a Halfords 21mm 1/2 inch drive, with a 18 inch breaker, and couldn't budge it. Clearly not enough wheatabix for breakfast. Unfortunately I don't have a long scaffold pipe to extend the leaverage. I do have a large 500nm torque wrench but this is 3/4 inch drive. So have ordered a Teng socket, and will have a go with this wound right up to 500nm.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum