Member Since: 10 Nov 2008
Location: Granada
Posts: 125
Remote Locking from KeyFob not working (Again)
Ok, so a few months ago I reported here that my Remote Locking from the keyfob stopped working. It didn´t work for a month, or maybe more. Tried spare key, no joy... Didnt get time to send it into the local stealer, who probably wouldn´t have a clue anyway and would use 50man hours and replace every part known to mankind.
Anyway, the point is that one day it started working again, everything was fine and dandy once again. Didnt do anything different, it just worked.
That was about a month ago, so worked for 4 or 5 weeks no problem.
Yesterday. Stopped working again. How annoying is that ?
It must be a connection somewhere on the receiver unit maybe ? Any ideas ?
Thanks.
16th Aug 2010 1:06 pm
Q86ARR
Member Since: 23 Feb 2010
Location: Jersey
Posts: 378
Most likely cause would be the green and white wire from the receiver to the CJB. Seen a couple with faults along this wire.
16th Aug 2010 8:48 pm
Scott_Fred
Member Since: 10 Nov 2008
Location: Granada
Posts: 125
Great, thanks.
Can you help point me in the right direction to sort this error out ?
I have no idea even where the green and white wire would be.
Cheers.
Q86ARR wrote:
Most likely cause would be the green and white wire from the receiver to the CJB. Seen a couple with faults along this wire.
16th Aug 2010 8:52 pm
Scott_Fred
Member Since: 10 Nov 2008
Location: Granada
Posts: 125
Anyone know where I will find this receiver and green and white wire ?
Also, what is a CJB ?
Thanks for any advice.
17th Aug 2010 10:35 pm
top-tech
Member Since: 05 Aug 2010
Location: hertfordshire
Posts: 31
remote receiver
the remote receiver is situated behind the head lining in between the centre front seats behind the light trim.the common fault is the splice joint for the green wire or green/white wire which is located behind the tread panel in the left front door area in the wiring loom.open loom and inspect splice under the blue sticky tape? good luck 8)
20th Aug 2010 11:48 pm
Scott_Fred
Member Since: 10 Nov 2008
Location: Granada
Posts: 125
Re: remote receiver
Probably a silly Q, as I am new to all this... I have a left hand drive model, will the loom still be on the left ?
Any pictures anyone, of what I should be looking for ?
What will the fault in the splice joint ? Just not connecting, or what ?
Thanks for all your help. Appreciate it. Great Forum.
Cheers.
top-tech wrote:
the remote receiver is situated behind the head lining in between the centre front seats behind the light trim.the common fault is the splice joint for the green wire or green/white wire which is located behind the tread panel in the left front door area in the wiring loom.open loom and inspect splice under the blue sticky tape? good luck 8)
21st Aug 2010 11:20 am
joness7
Member Since: 09 Feb 2006
Location: West London
Posts: 233
More Help!!
Help!!
I'm trying to make this repair too, but don't fully understand were I'm looking.
If I'm sat in the passenger seat of a RHD car, is the treadplate mentioned directly in front of me? Or is it to the left side, near the bonnet release handle? Or is it another name for the sill cover?
About to start pulling the trim of my car apart, so any help would be gratefully received!!
Thanks
Steve J2018 1.5Ti Skoda Octavia - dull as f&ck
2019 D5 SdV6 SE Anniversary - black/black - good riddance!!
2010 D4 TDV6 HSE - Nara Bronze with black - now gone!!
2006 D3 TDV6 HSE - Buckingham Blue with Alpaca - now gone!!
BMW R1200GS - also blue, also gone!!
Honda CRF1000L Africa Twin DCT - Dakar colours
Husqvarna Svartpilen 401 - the Black Arrow
22nd Jan 2011 1:32 pm
wilxite
Member Since: 11 May 2010
Location: Worcestershire
Posts: 1
I have exactly the same issue so, I've removed both the roof lining down and the wiring loom cover, I've located the receiver unit and there's two wires that run to it 1) a green/white wire and 2) a blue wire.
I traced along the wires and I can find no splice - although a large proportion is hidden within the loom itself. It runs down the near side A post and disappears out of view.
I've checked with a multimeter and there's not 12V on the green/white wire, but I'm reticent to do any more until someone can shed some light on the issue.
7th Feb 2011 7:25 pm
M.V.Gregory
Member Since: 31 Jan 2011
Location: Halesowen West Midlands
Posts: 6
Hi.
Did you sort out this problem as I have the same ?Tried new reciever still no luck.There isnt 12v on the green and white wire to the reciever so I expect this is the problem, Been sugested new body control unit (mega bucks)
Looked for wire in loom in footwell but cant find it, is it possible to to put a new 12v supply to reciever to cure the problem? can anybody help PLEASE.
Mal.malcolm
20th Feb 2011 4:39 pm
LURCHER
Member Since: 27 Jan 2007
Location: Hampshire uk
Posts: 58
I have now found the loom in the left hnds side tread plate and found 2 splices covered in tape one which is 3 red going to 6 red came apart as I touched it and the other one which is green and white appers sound but I will redo it anyway. Anyone know what the red wires are ? I suspect speakers but they seem to be working .[/img]D3 x2 D4 XS
110 Crew Cab
16th Mar 2011 6:58 pm
Randylover
Member Since: 31 Jan 2011
Location: Staffordshire
Posts: 1172
Lurcher,
the red wires will most likely be the illumination to the window switches on the doors, it was on mine, and along the loom just about level with the front of the seat will be the two or three green/white wires that all go together in a one ended black sealed terminal, on mine this looked as good as new , but i cut it of anyway and re-joined them together and it fixed my problem,
hope this helps
This is the offending conector
Andy05 TDV6,"S" in all colourcoded Zermatt silver,7 seats winter pack HK 6cd stereo,Dual climate,Xenons,
Mods:
Re-Con Engine,De-Tango,Reverse camera,Fog/DRl lights,Aux Battery, perm Aux socket in boot,LED Volt meters in roof panel,Built in tom tom, Strobes fitted in grille, Aux switches for trailer lights fitted in roof panel,Roof Rails,Grille conversion
16th Mar 2011 9:40 pm
LURCHER
Member Since: 27 Jan 2007
Location: Hampshire uk
Posts: 58
green
that is excactly like the green and white join in mine so will try that today , did you solder or crimp ?D3 x2 D4 XS
110 Crew Cab
17th Mar 2011 9:07 am
Randylover
Member Since: 31 Jan 2011
Location: Staffordshire
Posts: 1172
I crimped mine then taped it up all works fine now
Andy05 TDV6,"S" in all colourcoded Zermatt silver,7 seats winter pack HK 6cd stereo,Dual climate,Xenons,
Mods:
Re-Con Engine,De-Tango,Reverse camera,Fog/DRl lights,Aux Battery, perm Aux socket in boot,LED Volt meters in roof panel,Built in tom tom, Strobes fitted in grille, Aux switches for trailer lights fitted in roof panel,Roof Rails,Grille conversion
17th Mar 2011 7:32 pm
LURCHER
Member Since: 27 Jan 2007
Location: Hampshire uk
Posts: 58
Job done
Many thanks all ,now all I have to do is get refund on the 2 keys I bought,Soldered heat shrunk and taped.D3 x2 D4 XS
110 Crew Cab
19th Mar 2011 1:12 am
paul4
Member Since: 30 Dec 2009
Location: Wales
Posts: 6
Could you please tell me if the connection to repair is located in the loom next to the front passenger seat or the rear?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
