Member Since: 28 Feb 2018
Location: Larkhall
Posts: 1
Hi everyone,
since a few weeks now I am the proud owner of a 2006 Disco 3 . I have sourced a Thermo Call TC3 unit from Germany that finally arrived today after some delay due to extreme weather .
I have spent some time reading on this forum and elsewhere about fitting a remote or timer to control my FBH and have the following question:
Where on the TC3 do I connect the cable that goes to Pin 2 on the FBH control plug?
Hope that you can help me so that I can fit this during the next weekend...
6th Mar 2018 4:30 pm
denjohannes
Member Since: 08 Aug 2017
Location: 54456 Tawern
Posts: 8
Hi,
do I understand right for the TC3 :
Pin 1 (10-30v + in) to Battery plus
Pin 2 (GND) to Battery minus
Pin 6 (W-Bus) to Pin 2 of the Webasto unit
The picture https://www.disco3.co.uk/gallery/albums/us...e~149.jpeg shows it nicely . unfortunately I can not see where the green connector is going to , blue goes to 6 , red goes to 1 , but the green one ? I assume its 2 , correct?
That´s all ? Is this correct ?
THX
J... nur tote fische schwimmen mit dem strom ...
Last edited by denjohannes on 6th Dec 2018 10:34 pm. Edited 1 time in total
6th Dec 2018 8:58 pm
trailhound
Member Since: 27 Aug 2015
Location: Colchester
Posts: 697
Member Since: 08 Aug 2017
Location: 54456 Tawern
Posts: 8
Just for those who still struggle as I (noob) did :
TC3 ("D" series)
Pin 1 to battery plus (red cable)
Pin 5 to battery minus (brown cable)
Pin 6 to Bus input ( input 2 in the 8 wire socket in the heater) - check the wiki how to connect the plug and the socket
App:
-no external temp sensor used - app on "internal sensor"
-make sure to only use the last 7 digits of your phone number for installing - I had an error because of using the complete one
- it works - just sends me the message "unknown error" to the phone - but works . will see how to get this sorted . Tomorrow i will built it in properly incl. the red light button which I will bring to some place in the inside,,,... nur tote fische schwimmen mit dem strom ...
27th Dec 2018 7:49 pm
OllieZuerich
Member Since: 15 Dec 2023
Location: Tallinn
Posts: 3
Hi, it has been many years since the last post in this thread.
I have not found any step-by-step TC3/4 installation guide for D3 from anywhere which is a pity.
It would have been nice if someone actually wrote it up here.
I have been offered a TC4 for my D3. I have read the TC4 manual and surprisingly it does not actually describe the whole installation process.
The manual does say that the GSM module needs to be installed inside the cabin. So how have you solved it?
Also, why connecting it directly to the battery, when Altox at the same time gets installed behind the cabin headlight switch, wires connecting to a ground wire and to a always on 12V wire.
Any thoughts would be appreciated!
17th Dec 2023 5:16 pm
DISCO3WINE
Member Since: 28 Jul 2019
Location: MORAVIA
Posts: 3
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum