Member Since: 15 Jan 2010
Location: Stockholm
Posts: 808
Bodsy wrote:
urhunden,
did you read the initial instructional information by Flack....? It tells you where you can get them (in the UK at least) but it then gives you a starting point. Plenty of them on ebay also.
Yes, but these are cables with loose pin vonnectors and not as Robbos a full connector. Seems safer with a connector.
26th Jan 2015 10:18 am
Bodsy Site Sponsor
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset See It Here
26th Jan 2015 10:19 am
robbo770
Member Since: 29 Jan 2013
Location: Aberdeenshire
Posts: 2294
So did some more wire running and Fitting for the touch screen install
We will need to get one of these to split the aerial feed to the radio and the touch screenðŸ‘
Click image to enlarge
Click image to enlarge
Click image to enlarge
This will plug into the cable behind the cd/ radio media unit
I then made and feed my DAB unit to the drivers Center consule hiddy hole
I then tidyed up the area around the touchscreen and finished all my connectors
I connected my Faultmate up and ensured parking camera is on in my ccf and also set the DAB to fitted.
Couple of option so will have to play with it a bit to see if I can get some life from the unit.
Bennie does your reversing screen on your RRS unit Pop up straight away?? Or only once the speed sensor detects backwards movement??
Looking good Robo, the rear view camera should work without the speed pulse wire, I could not get mine to work at all and ended up fitting a D4 Gvif unit so I could use my rear view camera.
Interested to see if the TMC works once you connect the FM aerial up!!
Flack
26th Jan 2015 5:55 pm
robbo770
Member Since: 29 Jan 2013
Location: Aberdeenshire
Posts: 2294
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
robbo770 wrote:
Bennie does your reversing screen on your RRS unit Pop up straight away?? Or only once the speed sensor detects backwards movement??
Cheers Rob
Mine works without any movement at all. In fact just ign on and put it in reverse and it switches ok.
I did have the epb OFF, don't know if the logic changes if the epb is ON? Worth checking though, so will try it in a bit. Bodsys Brake Bible
IID Pro MV License - D3, D4 & RRS - Enabling, Updates, D4 & RRS Timed / Remote Climate, D4 Bluetooth fitting
PM me for details
Owner of the original "Beanie" grille
D4 & RRS style D3 grilles made to order
26th Jan 2015 11:16 pm
robbo770
Member Since: 29 Jan 2013
Location: Aberdeenshire
Posts: 2294
beanie wrote:
As above, no movement required
Robbo, not sure FM will enable the screen setting??
Mike is tasked with the unlock on Sat if he's updated his firmware
Got all my camera wires solider onto coaxial connectors today and spliced into the speed sensor wiring on pin 21 at the old dvd unit.
Found I had a joint fault for my front screen TV/DVD feed from the RSE , so traced and fixed as well. Bummer!!
Very impressed with the new screen in operation, much faster, it evens knows where it is now with the GPS signal on.
Have to plug the Faultmate in tomorrow and clear all faults as had the handbrake and terrain selector off for a while today trying to find my to fault.
Also had to replace my rear camera as it had died the week before but all done now.
Even ran my blind spot dash cross over wiring loom whilst in there
Still got the wade sensors loom to run and fit in the module
Not much free space anymore
Sat can't come quick enough, or it will be a GVIF for a D4!!!FFRR SC 4.2
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
, so traced and fixed as well. Bummer!!
