- You are currently viewing DISCO3.CO.UK as a guest - Register to take part or Log In
1967jester
Member Since: 05 May 2010
Location: Usually in the North East though I have been known to travel
Posts: 4484
  
|
| LED Trailer lights issue. UPDATE 18 Oct |
|
Just had my trailer tarted up & have added some nice bright LED's, however..
Plug lights into car (56 plate D3 with factory fitted trailer & caravan sockets) indicators on trailer pulse either with or without key in ignition/engine running, no trailer symbol showing on dash, all other lights work ok.
Just added 2 resistors between earth & indicators as advised by local LR specialist, things still the same but the lights are brighter.
Any ideas suggestions appreciated.
Thanks in advance, Paul. Paul.
06 Java Black HSE - gone
12 Baltic Blue HSE - gone
15 Fuji HSE Lux
Club Biscuits, mmmm nice!
Traxide/Luna hybrid & Yellow top
Some Prospeed bits
+ some other stuff
Club N.E.R.D.s.
Last edited by 1967jester on 18th Oct 2013 8:02 am. Edited 1 time in total
|
 11th Oct 2013 1:16 pm |
|
|
Bushwanderer
Member Since: 27 Nov 2007
Location: Northern Rivers, NSW, Australia
Posts: 2050
  
|
Hi Jester,
I may have misunderstood you, but the resistors should be placed in parallel with the indicator lights. (A recent post on here says that only one light needs to have the resistor fitted, but I can't confirm that.) The Bearded Dragon
|
| 12th Oct 2013 12:20 am |
|
|
Fogga
Member Since: 20 Jul 2009
Location: Tromsoe
Posts: 89
 
|
Me and a friend have also just upgraded his trailer with LED lights and had the same pulsing on the blinkers. It was only a problem on the D3, not a "normal" car. We also tried with resistors but the voltage is too low for the resistors to work properly (at least the ones we got hold of). We ended up using one 4 pin relay for each blinker on the trailer because the pulse on the blinkers from the car is too low to close the relay. Same relay you would use for extra lighting on the car. If you also want the trailer to blink inside the car you have to have a resistor on each blinker as well, connected to or after the relay. We put the resistor after the relay so it doesn't have power all the time and getting hot.
I am still testing to see if resistors on the main lights on the trailer also to get the D3 to turn off pdc while reversing.
|
| 12th Oct 2013 3:09 pm |
|
|
1967jester
Member Since: 05 May 2010
Location: Usually in the North East though I have been known to travel
Posts: 4484
|
Cheers chaps, chap at trailer place onto it now. Paul.
06 Java Black HSE - gone
12 Baltic Blue HSE - gone
15 Fuji HSE Lux
Club Biscuits, mmmm nice!
Traxide/Luna hybrid & Yellow top
Some Prospeed bits
+ some other stuff
Club N.E.R.D.s.
|
| 12th Oct 2013 4:38 pm |
|
|
1967jester
Member Since: 05 May 2010
Location: Usually in the North East though I have been known to travel
Posts: 4484
|
Update as of yesterday.
Resistors now in parallel - fault still present.
Trailer tried with FFRR - fault still present.
Trailer tried with Defender - fault still present.
Trailer tried with Ford/Mitsubishi & a VW - No fault present.
Have just PM'd Liam to see igf LR can advise but thought i'd ask you guys to get thinking caps on again.
Thanks in advance.
Paul. Paul.
06 Java Black HSE - gone
12 Baltic Blue HSE - gone
15 Fuji HSE Lux
Club Biscuits, mmmm nice!
Traxide/Luna hybrid & Yellow top
Some Prospeed bits
+ some other stuff
Club N.E.R.D.s.
|
| 18th Oct 2013 8:01 am |
|
|
chud
Member Since: 05 Oct 2013
Location: Dorset
Posts: 72
|
What size resistors did you use?
|
| 19th Oct 2013 6:51 am |
|
|
Randylover
Member Since: 31 Jan 2011
Location: Staffordshire
Posts: 1172
 
|
When I had same problem I cured it by fitting a 7 way by pass relay, cost £15 from good motor factor or motor electrician/caravan workshop.
All I did was wired it up and used the indicator wire only and problem sorted instantly
A cheap fix that worked, I did do a post about it but not sure where it is.
Hope this helps
Andy 05 TDV6,"S" in all colourcoded Zermatt silver,7 seats winter pack HK 6cd stereo,Dual climate,Xenons,
Mods:
Re-Con Engine,De-Tango,Reverse camera,Fog/DRl lights,Aux Battery, perm Aux socket in boot,LED Volt meters in roof panel,Built in tom tom, Strobes fitted in grille, Aux switches for trailer lights fitted in roof panel,Roof Rails,Grille conversion
|
| 19th Oct 2013 8:34 am |
|
|
1967jester
Member Since: 05 May 2010
Location: Usually in the North East though I have been known to travel
Posts: 4484
|
@ Chud - trying to confirm, 1st set were suggested by LR service centre from moterbike shop, 2nd set not sure.
Will get guys to look into bypass unit.
Cheers. Paul.
06 Java Black HSE - gone
12 Baltic Blue HSE - gone
15 Fuji HSE Lux
Club Biscuits, mmmm nice!
Traxide/Luna hybrid & Yellow top
Some Prospeed bits
+ some other stuff
Club N.E.R.D.s.
|
| 19th Oct 2013 11:23 am |
|
|
|
|
chud
Member Since: 05 Oct 2013
Location: Dorset
Posts: 72
|
Thats a posh made up name for a waterproof box full of resistors. 
|
| 19th Oct 2013 3:09 pm |
|
|
Nasher
Member Since: 07 Mar 2009
Location: Clanfield, North of Pompey - UK
Posts: 2817
|
So what’s the answer to this then?
Apart from the stupidly expensive box of resistors.
I’m in the middle of the issue myself as I’m converting our boat trailer to Waterproof LEDs that I can leave on and reverse in the water with.
I purchased some specific 6ohm resistors before I started the project.
The 12V ones here:
http://www.furneauxriddall.com/cgi-bin/sh0...LR12#aLR12
Without a resistor fitted the indicators flash constantly with the Canbus signal and the car doesn’t realise the trailer is plugged in as the dashboard trailer indicator lamp does not illuminate.
Fitting the resistors, in Parallel, causes the car to recognise the trailer is plugged in and the trailer indicator lamp illuminates.
But the indicators still flash constantly with the Canbus signal.
So we have two things to think about.
The car needs to see a higher resistance than the LEDs provide before it thinks a trailer is plugged in. This is what the Resistors do.
But the value of the normal Canbus/LED corrector resistors isn’t enough to stop the LEDs reacting to the Canbus signal.
Has anybody had any luck with higher value resistors?
Nasher. Heaven doesn't want me, and hell is afraid I'll take over.
|
| 20th Oct 2013 5:21 pm |
|
|
Randylover
Member Since: 31 Jan 2011
Location: Staffordshire
Posts: 1172
|
Feel a bit like a parrot,
7way by pass relay 👠 05 TDV6,"S" in all colourcoded Zermatt silver,7 seats winter pack HK 6cd stereo,Dual climate,Xenons,
Mods:
Re-Con Engine,De-Tango,Reverse camera,Fog/DRl lights,Aux Battery, perm Aux socket in boot,LED Volt meters in roof panel,Built in tom tom, Strobes fitted in grille, Aux switches for trailer lights fitted in roof panel,Roof Rails,Grille conversion
|
| 20th Oct 2013 5:35 pm |
|
|
Nasher
Member Since: 07 Mar 2009
Location: Clanfield, North of Pompey - UK
Posts: 2817
|
Thanks Randylover, but need a bit more info.
You say you only connected the indicator wires.
Did you not connect the additional 12V supply that the bypass relays appear to need?
Or am I looking at the wrong thing?
I assume the car recognises the trailer is plugged in?
What make did you use?
Thanks
Nasher Heaven doesn't want me, and hell is afraid I'll take over.
|
| 20th Oct 2013 5:39 pm |
|
|
1967jester
Member Since: 05 May 2010
Location: Usually in the North East though I have been known to travel
Posts: 4484
|
Having the lights changed back to std bulbs as it's just way too much hassle trying to get this sorted.
Main issues involve use of 2 vehicles, both LR & 1 trailer. Paul.
06 Java Black HSE - gone
12 Baltic Blue HSE - gone
15 Fuji HSE Lux
Club Biscuits, mmmm nice!
Traxide/Luna hybrid & Yellow top
Some Prospeed bits
+ some other stuff
Club N.E.R.D.s.
|
| 22nd Oct 2013 1:15 pm |
|
|
Fogga
Member Since: 20 Jul 2009
Location: Tromsoe
Posts: 89
|
How did you wire the relays? Just wondering since we use the trailer we upgraded to LED on 2 D3's without any problems.
|
| 22nd Oct 2013 2:05 pm |
|
|
|
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
|
|
