Member Since: 06 Mar 2017
Location: Lost
Posts: 5024
What kind of pressure / flow is there at the schrader? The rail pressure reading will be pretty meaningless until it fires up. If you are not getting a minimum 1.3 litres p/min at the schrader either the filter is blocked or the lpfp is shot.
But, the above is irrelevant if the original fault codes still present? yµ (idµ - eAµ) ψ=mψ
22nd Apr 2024 6:58 pm
GreatWhenTheyWork
Member Since: 26 Jun 2023
Location: Kent
Posts: 30
GreatWhenTheyWork wrote:
Update, following Robbie’s thread….
Lpfp is pumping 1.4 Ltrs in a minute.
Pump pressure at the test point in the engine bay is a steady 6 psi, while cranking.
I rigged up a fuel pump and fuel supply to feed into the test point, the engine did try to fire twice but that was it.
I still need to dig into the engine bay and check the hpfp belt, a job for the weekend.
Member Since: 06 Mar 2017
Location: Lost
Posts: 5024
Open a high pressure fuel line and have someone crank the engine. Fuel should continuously spurt from the open line (allow for residual!!) If there's no fuel spurting, either the HPFP is kaput or the belt has snapped since you do have a good lp feed!
One caveat though, just be careful here as the fuel if under high pressure will hurt you, and never attempt this with a running engine!yµ (idµ - eAµ) ψ=mψ
23rd Apr 2024 1:25 pm
GreatWhenTheyWork
Member Since: 26 Jun 2023
Location: Kent
Posts: 30
Member Since: 29 Apr 2024
Location: Hampshire
Posts: 1
Hi, did you get a fix for this, I have the same issue?
7th May 2024 2:19 am
elliott
Member Since: 25 Jul 2024
Location: southampton
Posts: 1
GreatWhenTheyWork wrote:
Hi, ok great will give this a try and feed back.
Hello,
What was the fix?
I am seeing fuel come out of the schrader valve so LPFP must be working. Fuel pressure MPa is reading 0 pressure, desired is 30.
The only fault code I am getting is P062A. Could the fuel module in the rear of the car be faulty? LPFP was changed approx 4 months ago
25th Jul 2024 8:53 pm
Browny90
Member Since: 19 Jul 2016
Location: Ashbourne
Posts: 698
Likely HPFP belt snapped..Disco4 MY16 SDV6 Landmark Black
Disco4 MY12 SDV6 XS Orkney Grey (Gone)
Defender 90 200tdi Completely rebuilt.
25th Jul 2024 10:05 pm
Spukifrosch
Member Since: 15 Aug 2024
Location: Lüneburger Heide
Posts: 1
Hey folks,
my My13 D4 would not fire up.
History:
I fueled up, drove a few Kilometers and felt a little interruption in the acceleration. I´ve had not that mutch attentive to my Popometer (Buttmeter) that time , could have been a crach in the road.
so I was not that much worried.
Drove a few kilometers on the Autobahn, took a 15 minut break , tried to start, it turns but would´t fire up.
No fault code
After i worked trough Robie´s guide, i´m pretty sure my LPFP went to Walhalla.
Is here anyone who had changed just the pump from the sender unit?
15th Aug 2024 11:49 am
GreatWhenTheyWork
Member Since: 26 Jun 2023
Location: Kent
Posts: 30
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
