Member Since: 31 Aug 2010
Location: retford'ish
Posts: 2225
Replaced a rear Panhard/Tie rod with pics
Hi,
I changed the N/S rear Panhard or Tie rod today as Amber noted at last service by dealer "play in inner ball joint" it was a straight forward job
Jack up the car and make safe, I just leant it against the caravan
I also put an axel stand at the rear as well
With the wheel still on, hold at 3 & 9 O'clock and check for any movement, I could feel slight play/knocking confirming the inner ball joint same at 12 & 6 and nothing felt
I had a trolley jack under the lower arm and a bottle jack under the chassis incase any adjustment was going to be needed to refit the rod, but this was not needed as there is no load on the rod
New parts from AF
the bolt is 18mm and the nut is 21mm both new.
I took this pic before removing the old arm and Murphy's law the bolt actually fits the other way around
with the metal inner bush fitting into a recess
My arm had been previously fitted high in the chassis bracket slot
The gap should be 10mm from the bottom of the ball joint to the bottom of the bracket
(measured on the other side)
Thanks to SteveNorman for that info
I had intended to set the length of the New rod to the same as the old, but as I was now going to set the new rod at the 10mm gap at the chassis mounting bracket I measured from this bracket to the brake caliper 540mm
Moving the ball joint end down to the 10mm gap made a +3mm difference to the measurement which I would think would add a fair bit of extra rear toe in
I tightened the nut on the ball joint/chassis end first so the square fits into the slot of the bracket more easily, then the bolt through the bush end.
Adjusted the bar back to the 540mm
The lock nut is 26mm and the bar needs a 17mm to make adjustment
Put everything away and put the kettle on,
think it should only be a 30-40 min job, so the photos must have took the other hour
Just got to get the wheel alignment done now UPDATE n/s I replaced all good for toe but camber a bit out and the o/s way out for camber ! All correct now
Member Since: 23 Dec 2013
Location: under the car
Posts: 404
You have replaced the entire panhard rod / toe link.
Can the bush be replaced alone and if so, what is the part no.?Achim
own garage certified LR tech
Disco 2 TD5 MY 2001 - gone but still driven by another owner
Defender 110 TD5 driving me bananas with all faults
Disco 3 TDV 6 HSE MY 2005 gone @280.000 km
Disco 4 SDV 6 HSE MY 2012
4th Nov 2017 1:49 pm
riverblanche
Member Since: 31 Aug 2010
Location: retford'ish
Posts: 2225
Hi,
I never asked
it was the inner ball joint that was cream cracked on mine
and from memory the £ of the complete unit would not have been worth the time or effort for me
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
same at 12 & 6 and nothing felt
