barce1987
Member Since: 18 Jun 2014
Location: barnsley
Posts: 33
|
Alright gaz I've tired the hold econ and circulation button.
Econ starts flashing then goes off and blower come on as normal . Turn key off then bk on and no flashing . But it's still cold on left side and hot right side . I've tyres a new control unit and still same so can't be that . What else do u think it could be ? Thanks dean
|
31st Oct 2014 7:30 am |
|
|
MatelotBoy1
Member Since: 30 Aug 2021
Location: Merkelbeek
Posts: 9
|
heater matrix removal - dash out? |
|
So, it's happened, heat on driver's side, no heat on passenger...I've flushed the matrix which did not fix it (tbh, not much crud came out even after using limescale remover etc) and now I need to replace it.
Having a 2010 LR4 i'm not sure if there are any differences with the LR3, but I cannot see how the matrix will come out unless all the plastic centre console trim is removed...has anyone done this? or am I looking at a complete dash removal (please God, no!). Internet pictures show someone taking it out with a slight mod of the panels underneath, but that was not a LR4 (RRS I think( and it's not the same...any advice greatly appreciated.
TIA.
|
1st Sep 2021 7:01 am |
|
|
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10530
|
Investigate as per RRS.
Should come out like that, as long as the pipes are joined down there.
|
1st Sep 2021 7:19 am |
|
|
|
MatelotBoy1
Member Since: 30 Aug 2021
Location: Merkelbeek
Posts: 9
|
I don't suppose you have a 'how to' guide when it comes to taking everything apart?
I am guessing that the entire centre console must be removed, along with all the radio/control panel units in the centre dash?
I am hoping that the steering wheel and console can stay in place, or do you really mean the whole dash has to come out?
I've watched a video online where they remove the entire dash 'live' but I get the feeling I don't need to go to those lengths just to slide the matrix out from underneath (I could be wrong!).
|
1st Sep 2021 12:53 pm |
|
|
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10530
|
Console usually has to come out, so the dash can move.
I even had to do it to change the glovebox!
|
1st Sep 2021 1:07 pm |
|
|
MatelotBoy1
Member Since: 30 Aug 2021
Location: Merkelbeek
Posts: 9
|
I thought the glove box was held in place with 2 hinge pins that you can remove with a little home made tool to 'squish' the end tabs so you can pop the pins through?
|
1st Sep 2021 1:46 pm |
|
|
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10530
|
It was the rear part I needed to change
|
1st Sep 2021 3:20 pm |
|
|