Killerlynx1991
Member Since: 29 Jun 2021
Location: Rugby
Posts: 11
  
|
Hi everyone had quick look through the forum but I can't find what I'm looking for I have rebuilt my hole engine and refitted it back cranks over but not firing I didn't do the timing on this but I think it might be wrong dose anyone know the procedure to timing it and doing it through the flywheel I would be very grateful for the help as its taken me a while to get this job done and I haven't even driven it yet 😂😂 but this is stressing me out thank you
|
 1st Sep 2021 8:24 am |
|
|
Flack
Member Since: 06 Sep 2006
Location: Preston Lancashire
Posts: 6276
 
|
If you have rebuilt it and not checked the timing, why try and start it, if it was out it might have damaged the engine.?
You will need to remove the starter motor and fit the flywheel locking tool, then turn each camshaft to the locating holes to line so you can then insert the two cam locking pins.
Then make sure all the slack in the belt is removed by going anti clockwise from the crank pulley to the belt tensioner and tighten to the little window on the tensioner.
There is a load of posts on this subject.
Flack 
|
| 1st Sep 2021 9:04 am |
|
|
Killerlynx1991
Member Since: 29 Jun 2021
Location: Rugby
Posts: 11
|
I get what you are saying I went with the fact I paid someone to do it but I don't know if its correct now that I have tried to start it that's the problem I'm facing but thank you for your reply
|
| 1st Sep 2021 9:07 am |
|
|
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10530
|
It does take a lot to get these engines to start after a rebuild
Takes a while you get the fuel going.
There is a tyre pressure valve at the rear of the engine.
Bleed air out of that.
You need a well charged battery.
Spray a small amount of easy start into the top Y piece.
Not too much as it can wreck the engine if it pools inside
Then lots of cranking. Stop after 30 seconds and switch off.
|
| 1st Sep 2021 9:12 am |
|
|
Killerlynx1991
Member Since: 29 Jun 2021
Location: Rugby
Posts: 11
|
Okay il give it another try with what you have said thank you
|
| 1st Sep 2021 9:59 am |
|
|
