Member Since: 10 Sep 2012
Location: Northampton
Posts: 1034
Can anyone help identify this connector
Evening All
While cleaning the MAP sensor this afternoon I noted this connector attached to the MAF wiring loom, it had been wrapped in black insulation tape that had started to fall off so I decided to replace the tape with self amalgamating. As you can see once I removed the old tape I found this:
Looks like a temporary 'fix' by a previous owner but it's not clear where it connects or why the terminals are bridged.
Thanks
Allan
30th Sep 2012 9:48 pm
WOODY179
Member Since: 01 Jun 2005
Location: Chesterfield
Posts: 3642
Is it the bonnet switch? Can't tell the position from the photo, but if its on the left handside near the headlight it could be that the previous owner had a problem with a faulty bonnet sensor switch on the alarm and instead of replacing it just shorted the connectinons as in your pic.
30th Sep 2012 9:53 pm
Robbie
Member Since: 05 Feb 2006
Location: ¯\_(ツ)_/¯
Posts: 17932
Hard to tell but looks like the connector for the bonnet latch sensor.
If it is, it's not the first to be bridged!Land Rover - Turning Drivers into Mechanics Since 1948
Member Since: 05 Feb 2006
Location: ¯\_(ツ)_/¯
Posts: 17932
Woody types faster than me!
Sensor appreciates a bit of WD40 cleaning which may bring it back to life if you want to try refitting it.Land Rover - Turning Drivers into Mechanics Since 1948
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
