Member Since: 18 Jun 2020
Location: Red Creek
Posts: 4
Also , do not connect your iPhone to the stereo system. It’s ok to charge it via the 12v power plug , but don’t plug into back socket to play music from your iPhone through the stereo. I found this also throws the computer out ,too advanced forthr Disco3’s computer.
5th Dec 2021 9:14 pm
NicoHarmsen
Member Since: 18 Jun 2020
Location: Red Creek
Posts: 4
All errors solved .
Trailers with led lights are a big problem for the computer. Use 21w incandescent bulbs or a load resistor kit . Reset all errors . All your problems solved . This was an expensive lesson for me . Also don’t use your iPhone through the stereo system . Charging from 12 v cigarette lighter ok .
17th Dec 2021 10:35 pm
Gastón did castelnuovo
Member Since: 15 Apr 2022
Location: Argentina
Posts: 15
Re: IID Tool Faults & Fixes please
F15KEY wrote:
I guess that these have all been covered before, but I'm loosing the will to live with our D3!
It keeps going into various fault modes and below is a previous grab from the IID report.
I've replaced the Air Suspension compressor, a complete AMK Kit and flashed the ECU for this, looking at the one removed it didn't look like anything was wrong, but hey, now has a new one for the next couple of years.
Changed the Brake Light Switch, this threw up many more codes that I could mention, so put the old one back on.
About to put in a new High Pressure Fuel Pump as LR say that is the problem.
So have you solved the problem with the new HPFP?? I'm having similar problems with my 2009 TDV6 LR3 with 115k on it
Before I fit the new one and void any chance of a refund if this doesn't fix it, HAS ANYONE GOT ANY OTHER SUGGESTIONS, please?
Many thanks
James
L319 - Discovery 3 2009
Vehicle scanned on 30-11-2021 8:34 pm
Using IIDTool BT V4.0 B2742
Body Control
B1B91-3A (2F) Seat tilt motor speed/position sensor - Frequency modulation/pulse width modulation failure - incorrect, has too many pulses
( on 29-11-2021 6:47:33 pm at 204810 km )
Cell Phone
U3003-17 (AC) Battery voltage - General electrical failure - circuit voltage above threshold
( on 30-11-2021 8:24:47 pm at 204930 km )
Engine TDV6
P117D-00 (68) Fuel volume regulator control exceeded maximum control limit
Parking Brake
U0100-87 (A8) Lost communication with engine control module/powertrain control module 'A' - Bus signal/message failure - missing a message
( on 29-11-2021 8:14:15 pm at 204820 km )
Suspension
C1A20-64 (2C) Pressure increases too slow when filling reservoir - Algorithm based failure - signal plausibility failure
( on 29-11-2021 7:30:12 pm at 204814 km )
Transmission
U2023-86 (AC) Control module network signal calibration data - Bus signal/message failure - signal is invalid
( on 29-11-2021 8:14:15 pm at 204820 km )
17th Apr 2022 2:41 am
terryall
Member Since: 17 Jun 2011
Location: Whitstable
Posts: 1433
I had the Christmas tree lights problem for almost a year and tried many remedies to no avail. Eventually, the fault was tracked down to a tiny leak in one of the front suspension air bags. It was only found by using a can of spray that plumbers use to detect gas leaks and was at the very top of the bag. Solved my problem by getting a new one and all was well afterwards.
17th Apr 2022 6:53 am
Sneakymickeyy
Member Since: 20 Dec 2021
Location: Høland
Posts: 11
Hi.
Was out driving to Day in the New snow on wooden roads when my dash lit UP gear fault and som on same as many Others here have talked about. But my car won't start now tried reading fault codes but engine gear body and all related to motion modules isn't showing up and alot of other codes on everything. And i can't turn off my Hazzard lights when the pics was taken the engine was running
23rd Nov 2022 9:20 pm
Yankee_Rover
Member Since: 02 Jun 2021
Location: Seattle
Posts: 183
Looks like your transmission is throwing a fault. I’ve had an issue with the TCM (bad grounding wire in the loom) that caused loss of communication with the transmission, and mayhem ensued. Car would not start after it was turned off. This all happened after driving on a washboard gravel road for a mile.
Try disconnecting your battery for 10 minutes. Might let you restart the car. If that fails, try using the parking gear bypass under the gear shifter (instructions in the owners manual under the “towing/servicing” section). Once in neutral, try starting again. I did all this and it allowed me to get back to pavement to get sorted.
Good luck!2008 LR3 HSE, 4.4L V8
24th Nov 2022 1:30 am
Sneakymickeyy
Member Since: 20 Dec 2021
Location: Høland
Posts: 11
Thx Will do tomorrow i taken det TCM in yesterday and put IT on my radiator to dry up battery is charging in my livingrom but check the rest of it tomorrow BTW (New to LD D3 got mine 1 year whit out any problems feel lucky after what I've read in here.)
TCM is the one behind the battery right?
24th Nov 2022 11:08 pm
Yankee_Rover
Member Since: 02 Jun 2021
Location: Seattle
Posts: 183
TCCM (transfer case control module) is behind the battery. TCM (transmission control module) is in the transmission, it’s part of the valve body. Fortunately true problems with the TCM are very rare, problems with them are usually wiring leading to the trans.
If you can pull diagnostic codes you’ll have a better idea. If you can do that, start a new thread and you’ll get more replies. 👍2008 LR3 HSE, 4.4L V8
25th Nov 2022 12:15 am
Sneakymickeyy
Member Since: 20 Dec 2021
Location: Høland
Posts: 11
My problem is that I can't see the tcm in diagnose norr tccm or ecu non of em shows up not abs or srs
25th Nov 2022 12:17 am
Yankee_Rover
Member Since: 02 Jun 2021
Location: Seattle
Posts: 183
Good news is that it sounds like there probably isn’t a problem with any of those modules. I’d start looking for a bad ground somewhere. There’s a main loom ground in the rear of the vehicle, left side, above the spare wheel well.
I think you’d best be served by starting a new thread for maximum visibility.2008 LR3 HSE, 4.4L V8
25th Nov 2022 1:17 am
aja4x4
Member Since: 14 Apr 2019
Location: Westbury
Posts: 2463
Check your battery terminals are tight, my securing bolt was tight but i had a crack in the clamp and you could move the clamp on the terminal.Andrew
D3 2.7tdv6 2005
D4 3.0 SDV6 Commercial died and gone to LR heaven
D5 3.0 SDV6 HSE
25th Nov 2022 6:14 am
gstuart
Member Since: 21 Oct 2016
Location: kent
Posts: 14146
Hi
Plus 1 what others have mentioned , also heard about some of the errors ur having with hazard light coming on , not starting and I wonder if ur instrument panel cluster may be at fault due to many modules that go through it
Can get it repaired but for the life of of me can’t remember who others have used
Fingers crossed it’s something simple , if u don’t get anywhere would at least try the connections on the back of ur instrument cluster are all ok
Can also do a can bus test using a multimeter TP is just short for test probe from ur multimeter
Disconnect the battery first then test
TP to pin 6 other TP to pin 14 , read ohms
TP to pin 3 other TP to pin 11, read ohms
Hope that also helps u
25th Nov 2022 8:42 am
Sneakymickeyy
Member Since: 20 Dec 2021
Location: Høland
Posts: 11
Figuerd it out its the park brake modul that's gone so bypassing it for the winter and will have to change it to the spring
27th Nov 2022 5:32 pm
Landyjem
Member Since: 11 Mar 2023
Location: Cheshire
Posts: 2
New to me disco 3 manual 2007
Hi everyone, have a d3 2007 which has just brought up loafs of error messages at once -after my other half power washed rhe car...
Attached is the fault codes, I had the handbrake auto release error, then hill descent fault, then transmission range change, and special programs unavailable.
Where do I start? Thank you jem [/u]
11th Mar 2023 11:13 am
aja4x4
Member Since: 14 Apr 2019
Location: Westbury
Posts: 2463
Start by charging the battery, reset the codes and see what comes backAndrew
D3 2.7tdv6 2005
D4 3.0 SDV6 Commercial died and gone to LR heaven
D5 3.0 SDV6 HSE
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
