Discoeast
Member Since: 19 Feb 2008
Location: Boksburg
Posts: 800
![](templates/vbnew/images/spacer.gif)
![2007 Discovery 3 TDV6 S Auto Zermatt Silver 2007 Discovery 3 TDV6 S Auto Zermatt Silver](../images/veh/zermatt_silver.gif)
|
Hi hzwart, back in the loop.
My installation is not done yet, waiting for a fuel pipe i've ordered ex UK.
I've gone with the 120B, depending where you have the space a 445 is
the next step. If you looked in my pic's, you would have seen the STD
setup for a post 07 D3.Thus my new filter would fit in the old pre 07 filter's
place. Sticking with the 120 B, you could get two of them in, "TIGHT" but
possible. The 445 would be too fat to fit two of, if you have the pre 07 you
may have a look in the engine bay, L.H.S, in front of the battery. A word of
warning there are 4 pipes linked to the filter systems. My plan is
to steer clear of this trouble spot, trace the supply line between the tank
and filter and plumb in the new one. D3 bullbar-spots-roof rack with spots-ladder-long range tank-swing out spare wheel carrier- upgraded tow bar-dash console-internal water tank-duel awnings-drawer system & T T.
|
20th Aug 2008 10:53 am |
|
|
hzwart
Member Since: 27 May 2008
Location: Mpumalanga
Posts: 25
![](templates/vbnew/images/spacer.gif)
![2010 Discovery 4 3.0 TDV6 SE Auto Stornoway Grey 2010 Discovery 4 3.0 TDV6 SE Auto Stornoway Grey](../images/veh/stornoway_grey.gif)
|
Hi Discoeast
I have taken some photos of the filter attached to the diesel pump. They are in my gallery. I will now take a photo of the unit that was removed. Remember that the unit I have removed has been cleaned already
I will also make a modification to the main diesel filter. I have obtained two Racor units filtering at 2 micro's and will then proceed with the installation.
|
3rd Sep 2008 8:14 pm |
|
|
Discoeast
Member Since: 19 Feb 2008
Location: Boksburg
Posts: 800
![](templates/vbnew/images/spacer.gif)
![2007 Discovery 3 TDV6 S Auto Zermatt Silver 2007 Discovery 3 TDV6 S Auto Zermatt Silver](../images/veh/zermatt_silver.gif)
|
Hi hzwart,
Seeing that you are going for 2 x extra filter units, perhaps fit
a 10 micron filter cartridge in the first one as a pre filter. Using two of the
same grade of cartridges would be defeating the object of the mod IMHO.
With that in mind, if the tank filter did block again Rip the condom
off the pump and let the Racor do the job
Still waiting for my pipe to start the conversion. And take some pic's
please.
Cheers. D3 bullbar-spots-roof rack with spots-ladder-long range tank-swing out spare wheel carrier- upgraded tow bar-dash console-internal water tank-duel awnings-drawer system & T T.
|
4th Sep 2008 7:36 am |
|
|
hzwart
Member Since: 27 May 2008
Location: Mpumalanga
Posts: 25
![](templates/vbnew/images/spacer.gif)
![2010 Discovery 4 3.0 TDV6 SE Auto Stornoway Grey 2010 Discovery 4 3.0 TDV6 SE Auto Stornoway Grey](../images/veh/stornoway_grey.gif)
|
Hi Discoeast
I intent to change the exsiting main diesel filter to a pre-filter to filter at 30 micron. The two Racor 2 micron filters will operate in parallel to ensure pressure drop is limited thereby getting close to 0.5 bar to the high pressure pump.
The reason the two Racor filters is operating in parallel is to reduce the flow rate though the filter therby increasing water removal in the diesel. With the capactiry of filters (I hope to be able to install) , I should be able to run with these filters far longer and with a higher reliability than the current system in SA with the poluted fuel.
|
4th Sep 2008 2:12 pm |
|
|