Home · FAQ · New Posts · My Posts · PMs · Search · Members · Members Map · Groups · Profile · Donate ·
Log In
|
- You are currently viewing DISCO3.CO.UK as a guest - Register to take part or Log In
PCT3
Member Since: 13 May 2017
Location: Kent
Posts: 144
|
Hi guys
Been hovering on the edge now jumped in
Hopefully someone may have the answer ' please '
I'm having trouble with low range not selecting D3 my07 any one know what terminals to test to proof switch?
|
14th May 2017 7:29 pm |
|
|
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10365
|
Try.
Engine on
In neutral
Press switch
|
14th May 2017 8:13 pm |
|
|
PCT3
Member Since: 13 May 2017
Location: Kent
Posts: 144
|
Thanks for the sound suggestion, but I teach and demonstrate 4x4s for a living have even tried it rolling slowly, stationary.
I think it's a little more than that, so want to proof the switch is working before moving on to ECU Then actuation motor.
|
15th May 2017 5:01 pm |
|
|
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10365
|
If you had an IID tool, I think you can test the switch operation.
Anyway, to try and answer your question, on an RRS.
You have an igntion supply in via fuse 24 (glovebox) to pin 20 red wire.
This is a common point for the switches and lights. (so if Hi is lit up orange, fuse should be ok)
The switch outputs are on pins 9 (red) & pin 10 (white)
|
15th May 2017 6:49 pm |
|
|
PCT3
Member Since: 13 May 2017
Location: Kent
Posts: 144
|
Thanks Pete
I have a IID tool on the way think I have other problems too but one thing at a time, high box ind lamp is lit so we are saying fuse good, thanks for the pin numbers can now check if I get a signal from the switch.
|
16th May 2017 4:38 pm |
|
|
PCT3
Member Since: 13 May 2017
Location: Kent
Posts: 144
|
An update on my high low box.
I have unplugged and cleaned connections to the transfere box, which seems to have cleared my solenoid fault tested switch with IID and getting no activity, does this mean I have o replace the switch panel?
Also been doing battery checks each morning.
Ign off voltage 13.8
Ign on voltage drops to 11.8
Will get battery load tested next week but the drop from off to on seems a little high any ideas?
|
28th May 2017 7:38 am |
|
|
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10365
|
The whole switch panel can be taken apart.
There are screws in the rear ?
and lots of tabs around the outside.
Go carefully.
I think there are TV remote style membrane type switches in there.
So the PCB needs a clean off with alcohol (on the gold switch points)
and the membrane on the black bits which touch it (need a careful clean - alcohol or washing up liquid).
Voltage look fine. Wouldn't waste any time investigating those.
|
28th May 2017 9:57 am |
|
|
|
Posting Rules
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
|
|
DISCO3.CO.UK is independent and not affiliated to Land Rover.