JimboTD5
Member Since: 28 Aug 2013
Location: Gower
Posts: 106
  
|
Hi guys, back to this I've had a look and can only find two holes along the front trim under the guide thing, is there any more? I've rodded down so far but can't seem to go any further and can't seem to get the side grille off cos I think their blocked from the bottom up? Only had a few drips since but all from different places 
|
 2nd Jan 2014 10:23 pm |
|
|
Thaz my boy blue
Member Since: 01 Jul 2013
Location: Fareham
Posts: 34
  
|
Hi,
One in each corner, two at front and two at rear each front goes down respective a pillar and rear track along above rear doors and down to drain out front of rear wheel arch. You will have to take out plastic wheel splats to see end of tubes.
The wing air intake grill takes a good hard pull , see on you tube a technique is to lift and pull quite hard, unfortunately you can break the clips. I broke one but grille does go back on fine. Seems brutal but not a lot of choice to get to end of tube. And I had same problem that I couldn't clear tube from top until I had cut bottom of tube wider and poked built up silt out.  Steveo
|
| 2nd Jan 2014 10:34 pm |
|
|
Thaz my boy blue
Member Since: 01 Jul 2013
Location: Fareham
Posts: 34
|
Sorry jimbo forgot to mention.....
Also to get to n/s/f I took off plastic wheel spats and you can reach up behind wing and you will find a opening identical to the grille side. The tube is in the same place as the off side with nothing in your way.
I managed to carefully cut end open with a razor blade. Be very careful not to push tube through into car cab and go very easy on the cutting !!! Steveo
|
| 2nd Jan 2014 10:40 pm |
|
|
JimboTD5
Member Since: 28 Aug 2013
Location: Gower
Posts: 106
|
Ok nice one mate hopefully have another go tomorrow if weather holds off!
|
| 4th Jan 2014 9:46 pm |
|
|
