Member Since: 09 Sep 2011
Location: Bangor
Posts: 8
Drivers window glass clamps / clips ?
Hi,
The drivers door window dropped into the door yesterday and after taking the door apart, it is just the 2 plastic clips that bolt onto the bottom of the glass that are broken. However, it seems they are very hard to buy.
Does anyone have any suggestions?
After a lot of Googling I found this rather dodgy looking website that I had never heard of :
<snip>
I was also thinking of trying to 3D print one. Does anybody have any suggestions on where else I could get some clips please?
This post has been edited by the site administration team: scam website link removed. Alternative (expired) eBay listing https://www.ebay.co.uk/itm/144290233102
20th Mar 2022 11:43 am
SpiderBaby D3 Decade
Member Since: 21 Sep 2007
Location: Liverpool
Posts: 1404
Is this what you're after?
I've only the one and it's off an 05MY rear near side door so I'm not sure if they're the same part - you'd need to verify it via a parts catalog.
I see no ships........
20th Mar 2022 8:05 pm
carcher
Member Since: 09 Sep 2011
Location: Bangor
Posts: 8
Yes that's the part thanks - but I need 2. Both are broken!
Anyone else have another?
20th Mar 2022 8:20 pm
Coo
Member Since: 01 Jun 2015
Location: Fife, Scotland
Posts: 284
If you are not keen on buying via that website....use eBay:
Member Since: 21 Oct 2016
Location: kent
Posts: 13854
Plus 1 ref what @coo has linked to as bought some for my front door
I also got some window glass clamps which were very useful keeping the glass up instead of using tape
21st Mar 2022 10:07 am
M3DPO
Member Since: 22 Sep 2010
Location: Notts.
Posts: 8154
Easier and safer to just lift the glass out It can when others can't,
It will when others won't,
It goes where others don't.
21st Mar 2022 1:34 pm
carcher
Member Since: 09 Sep 2011
Location: Bangor
Posts: 8
Is it hard to get the glass out and in? Do I need to unbolt the guide rail things?
21st Mar 2022 9:14 pm
M3DPO
Member Since: 22 Sep 2010
Location: Notts.
Posts: 8154
No, just remove the outside top seal taking care not to bend it, one screw holds it at each end then lift and twist the glass out from outside the car, two minute job It can when others can't,
It will when others won't,
It goes where others don't.
21st Mar 2022 9:56 pm
gstuart
Member Since: 21 Oct 2016
Location: kent
Posts: 13854
Hi @M3DPO
Hope u don’t mind me asking , but u mentioning the outer top seals , is that the same for all of them plse with regards to a bolt each end as I bought a set and wondered how they came out
Mine have started to bubble so instead of messing around with them bought the set of x4
Many thks
21st Mar 2022 10:05 pm
M3DPO
Member Since: 22 Sep 2010
Location: Notts.
Posts: 8154
Not a bolt a Philips screw on the very end possibly on the inside with the door open then lift the strip up, no need to be gentle in your case It can when others can't,
It will when others won't,
It goes where others don't.
21st Mar 2022 10:25 pm
gstuart
Member Since: 21 Oct 2016
Location: kent
Posts: 13854
Many thks and indeed can then just rip them off
21st Mar 2022 10:56 pm
M3DPO
Member Since: 22 Sep 2010
Location: Notts.
Posts: 8154
Just don’t bend the new ones as you will not get the kink out It can when others can't,
It will when others won't,
It goes where others don't.
21st Mar 2022 11:09 pm
gstuart
Member Since: 21 Oct 2016
Location: kent
Posts: 13854
Must confess thought I bought the wrong ones at first as they looked alot longer than the old ones, plus many thks for the heads up as ordered some new torx screws
Before I fit these I intend to put my smoke machine inside the cabin to double check where other places of water ingress are occurring
Thks again
22nd Mar 2022 12:55 am
fred1922
Member Since: 29 Sep 2021
Location: Bomaderry
Posts: 7
window clips
I made a pair from aluminium.
not pretty but did the job.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum