Member Since: 24 Jun 2021
Location: West Sussex
Posts: 428
Anybody increased standard ride height during calibration.
Just calibrated my suspension to standard 466mm front and 485mm rear. Now I’m thinking I would like to increase the standard ride height. Has anyone done this and was it ok or not. Thanks.
15th Aug 2021 4:58 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10547
Ppl have done it.
It applies to all modes though.
So access normal and off-road would all be a bit higher
So wouldn’t corner as well (or safely on road )
So be careful
15th Aug 2021 5:10 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 4907
I keep mine 10 mm below the calibrated setting for improved handling, not sure why you'd want to raise it higher though. You can program raised/lower settings with IID and select them as and when required, as well as the default!yµ (idµ - eAµ) ψ=mψ
15th Aug 2021 5:21 pm
discovery3ski
Member Since: 25 Dec 2012
Location: leicester
Posts: 735
How do you set it lower than the standard ride height please. ?
Is it a long job?Discovery 3 tdv6 HSE 2007
Alfa GTV CUP
Alfa 156 JTS
Alfa Spider TS
Alfa GT Cloverleaf
Volvo XC70
15th Aug 2021 5:42 pm
munst
Member Since: 16 Sep 2020
Location: GLOS
Posts: 155
I'm convinced mine rides higher than normal. Parked next to another d3 in the services yesterday and the difference between the back bumpers was noticeable. Need to get around to actually measuring it
15th Aug 2021 5:52 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 4907
discovery3ski wrote:
How do you set it lower than the standard ride height please. ?
Is it a long job?
5 mins wit GAP IID!
Select height settings so long as you are happy the default 466F/485R are correct, which the tool will ask you to confirm> Select raise or lower the suspension 5'10'15 '20 mm and confirm. I think 25 mm is the max but others will confirm. yµ (idµ - eAµ) ψ=mψ
15th Aug 2021 6:13 pm
Garwood56
Member Since: 24 Jun 2021
Location: West Sussex
Posts: 428
Interesting enough I’m doing this with the Autel AP200 tool. I seem to have the full software and not a Frey import, thus I have all the full features including all suspension maintenance. I put in current corner height values and then after it has gone through a raise and lower it asked for new values. 10mm up to front 475mm and rear 495mm. Seems to work and confirms calibration is complete and successful. If this tool hadn’t done suspension I was going to buy the Gap tool. Happy days 👍
15th Aug 2021 6:54 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 4907
Maybe you're adjusting it by changing the actual default calibration rather than adding a "new setting"!
In any case I suppose it won't matter so long as you are aware of it, but I must confess I have no experience of Autel.
With the IID you can add three or maybe four settings which you can then select as and when desired.
When you want to go back to standard "calibrated" height you just select default from the menu! yµ (idµ - eAµ) ψ=mψ
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum