Bubblehead
Member Since: 01 Jun 2020
Location: Horndean
Posts: 214
  
|
I loaded some bikes onto the rear bike rack this afternoon, and because there were 4 I put my lighting board on as the rear lights were partially covered by the bikes.
I then noticed that the red LED’s of the rear lights were flashing..
I unplugged the lighting board and they stopped.
While plugged in, they flashed with ignition off, doors locked, engine running etc etc. The only time they didn’t flash was if the lights were switched on.
Can anyone advise please..?
I’ve left unplugged as they’re staying on the car overnight and will plug back in while running tomorrow abs just have the lights on.
Thanks in advance 2005 Disco3 HSE Auto 😁
|
 8th Aug 2021 7:32 pm |
|
|
aja4x4
Member Since: 14 Apr 2019
Location: Westbury
Posts: 2462
|
Does your lighting board have LED indicators?
You may need to fit resistors in the wiring. Andrew
D3 2.7tdv6 2005
D4 3.0 SDV6 Commercial died and gone to LR heaven
D5 3.0 SDV6 HSE
|
| 8th Aug 2021 7:46 pm |
|
|
Bubblehead
Member Since: 01 Jun 2020
Location: Horndean
Posts: 214
|
No it doesn’t, I’ve used other light boards for trailers but if I’m honest, I don’t think I would have noticed if the rear lights would have been flashing then or not..? 2005 Disco3 HSE Auto 😁
|
| 8th Aug 2021 7:56 pm |
|
|
Globetrotter448
Member Since: 21 Mar 2017
Location: Londonderry NSW
Posts: 1791
 
|
Bubblehead wrote:
I then noticed that the red LED’s of the rear lights were flashing..
If these are LED's on the board then it will be due to not having resistors fitted as D#'s scan the lights continuously
|
| 12th Aug 2021 8:52 am |
|
|
