Member Since: 16 Dec 2017
Location: leicester
Posts: 4
Hi Guys And Girls auto gearbox help please
I have brought a d3 with a gearbox fault a few weeks back got the car cheap the guy had it a few months to travel the continent in i think it developed the fault from then it did have a suspension fault which i now have sorted and the cruise control wasn't working which i have sorted as well
Gearbox i have took all the under trays off the gearbox is completely clean compare to the tranfer box and the engine so looks like its had a recon/new box i have checked the oil and its still red and the levels are ok took the pipe off the oil cooler and they is oil there to
Symptoms of what is happening the gearbox runs absolutely fine 1st 2nd 3rd but will not shift into 4/5/6 even in the manual mode when i go down a hill and let off the throttle it will go in to 4/5/6 and i can accelerate in all them gear but after a few seconds it goes into fault mode i have some kind of noise coming from somewhere when i let go of the throttle then gose away when accelerating
what i have done so far i have replaced the lightbulbs in the brake lights for original checked the battery checked oil and electrical connections clean them had the one behind the battery out and looks fine the brake switch looks new i have got my own diagnostics machine
codes are
P0730 Permanent
P0735 Pending
U0122 Intermittent
U0159 thats the parking sensor on the rear i will be looking at over the weekend
B1A05 Permanent
U3000 Permanent
B1A56 Intermittent
B1D79 Permanent
U1A03 Intermittent
U2003 Intermittent
B1B70 Intermittent
B1D12 Intermittent
B1D12 Intermittent
I have gone through the procedure of installing a new gearbox on the diagnostics machine / clearing adaptive memory any ideas on what i should check next would be welcome thanks
16th Dec 2017 12:00 pm
Gareth Site Moderator
Member Since: 07 Dec 2004
Location: Bramhall
Posts: 26774
I'm not sure the oil should be red? Mine was green, although mine is an 8 speed. Hope someone hasn't filled it with ATF, because it needs special oil.
16th Dec 2017 12:44 pm
D3Ash
Member Since: 16 Dec 2017
Location: leicester
Posts: 4
I mean the transmission/gearbox oil is red thanks
16th Dec 2017 12:55 pm
sputnixb51
Member Since: 23 Apr 2013
Location: Morayshire
Posts: 833
As Gareth says it should not be red. Fresh oil of the correct type is slightly fawny yellow as it gets older it becomes darker and heavy brown. RED is ATF and wrong. You either get it force flushed with the correct fluid or use filos thread and replace the oil yourself in two or three goes and definitely replace the filter. When you have done that see what happens, if while you have the box open for filter replacement see what colour and condition the bank of solenoids are and the magnets, this will go a long way to telling you what you are up against.
16th Dec 2017 4:19 pm
lynalldiscovery
Member Since: 22 Dec 2009
Location: Maidstone
Posts: 7274
Read recent post where the correct spec oil can be red, cant remember who made it but someone checked the spec and it was right.
To the op check the selector linkage for play and adjustment, its on the rh side of the gbox, I havent a clue how to set the linkage up! but Im sure some googling will get you there.
16th Dec 2017 4:36 pm
waterbuoy
Member Since: 26 Oct 2013
Location: Argyll
Posts: 2922
This thread might help
Your first two fault codes are consistent with those reported in the TSB (but only those two); I suspect the real issue is likely to be the use of the wrong oil in the gearboc
https://www.disco3.co.uk/forum/6-sp-auto-g...ush+russiaCurrently 2009 Disco 3 SE, 2013 MY D4 HSE and 2016 D4 SE
Previously:
TD5 Defender 110 CSW (230k miles)
300TDi Disco 1 (289k)
4 RR Classics (300-350k each, 2 manual, 2 auto)
110 V8 CSW (220k)
S3 109 hi cap pickup (ex RN)
S2A 88 Safari SW with lpg conversion (bloody lethal)
16th Dec 2017 4:48 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10683
yeah oil should be yellow/gold.
There is one brand of red oil that could be ok, chances are its the wrong stuff though
Whether that really is your problem though, I'm not sure you will be lucky enough!
So which one is the gearbox code? and what does it mean?
If the oils coming out, i would be tempted to remove the solenoids ?
16th Dec 2017 5:11 pm
Bodsy Site Sponsor
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
Some people are using this red oil for flushing boxes....
Q8 transmission oil for ZF6/8 and 9 speed auto
How you can have one oil that covers all three gearbox oil specs is beyond me....
Some people are using this red oil for flushing boxes....
Q8 transmission oil for ZF6/8 and 9 speed auto
How you can have one oil that covers all three gearbox oil specs is beyond me....
Just my opinion of course......
You can't! There's different oils depending on the transmission and if you put Dexron III in it then it's pretty much scrap.1972 Range Rover Classic 2 door V8
2013 Land Rover Discovery 4 HSE - SCRAPPED
2016 Land Rover Discovery 4 Landmark
2022 Volvo XC40 T5 PHEV 282HP FWD 3 cylinder!
17th Dec 2017 10:22 am
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20841
You have 2 gear ratio faults, and most certainly the cause of your issues
These faults can be caused by a badly worn torque converter, low oil, or worn friction material
If the oil level is correct, it sounds as though the gearbox is needing stripped and inspected...My D3 Build Thread
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
ZF only approve their own Lifeguard oil.
There is a tech spec that ZF have to publish. It’s the oil companies that will claim it meets those specs, not ZF as they will always only approve/recommend Lifeguard.Bodsys Brake Bible
I think if it was my car, the first thing I would try would be Complete gearbox flush. Do a search on here for "Gearbox power flush"
Talk to the likes of BodsyIn Spain - 2018 F Pace - Down and out's Velar
In UK - Dare not say on this Forum
Gone - Lots of Lode Lane vehicles.
- Beta User
17th Dec 2017 10:37 am
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10683
Disco_Mikey wrote:
You have 2 gear ratio faults, and most certainly the cause of your issues
These faults can be caused by a badly worn torque converter,
Interesting. As I didn't have any cattle grid effect I assumed the TC was ok. But it can cause incorrect ratio too ?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
- Beta User 
