Member Since: 28 Mar 2012
Location: Darwin
Posts: 82
Cleaning EGR Valves
Gday All,
I have a 2008 TDv6 which every 20,000ks I clean the inlet Y piece. I tried to blank the EGR valves with not much success, so re-installed the pipework and the butterfly.
So far I haven't had the dreaded EGR problems, but its only a matter of time, so my question is
Has anyone cleaned thee EGR vavles and if so was it successful or should I leave sleeping dogs lie.
Car now has 120,000ks on it.
Cheers Bulletman
22nd Dec 2014 7:20 am
Robbie
Member Since: 05 Feb 2006
Location: ¯\_(ツ)_/¯
Posts: 17932
You have not said why your EGR blanking failed?
I've used EGR spray with good results but arguably the most common failure mode is mechanical and no amount cleaning will put the metal back together.
Land Rover - Turning Drivers into Mechanics Since 1948
Member Since: 28 Mar 2012
Location: Darwin
Posts: 82
The blanking was very intermittent, the car would be fine for a few days then it would go into limp mode with fault codes. I would clear the codes and it might be good for a while then it would fault code every 30mins, then not for a day.
It just got to difficult to continue driving that way.
See now you can get a software update to fix it but I am looking at trying another way first and see if it works.
Cheers Bulletman
22nd Dec 2014 7:33 am
bulletman
Member Since: 28 Mar 2012
Location: Darwin
Posts: 82
Robbie wrote:
You have not said why your EGR blanking failed?
I've used EGR spray with good results but arguably the most common failure mode is mechanical and no amount cleaning will put the metal back together.
What is the mechanical part that fails ?
Cheers Bulletman
22nd Dec 2014 7:34 am
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20836
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
