Forum · Gallery · Wiki · Shop · Sponsors


Home > Member Galleries > bbyer > Liftgate release mod
Click to view full size image
Flexible wire rope fishing leader 0.032" diameter exiting carpet
This is all you see of the completed mod.

The short little angled "line" about an inch long that looks like a piece of debris and is located a few inches "above" the support cable is actually the wire rope release cable exiting from under the carpeted lift gate cover.

I drilled a very small hole in the carpet and pushed the 0.032" diameter release wire thru and then slipped the loose end under the black plastic.

To release with the lift gate etc closed, from the inside, just pull the loose end free from under the black plastic and gently pull wire about 5mm, (1/4"), and the upper door catch should release. You will have to manually push the upper door out wards to actually effect opening, but you will already be inside the rear cargo area so that part is easy to do.

The assumption is that the lower door latch still works electrically and hence, the lower lift gate half will open as normal by pressing the usual button on the top left of the lower door half.
Rate this file (current rating : 5 / 5 with 1 votes)
Rubbish
Poor
Fair
Good
Excellent
Great

File information

Filename
LR3 Liftgate release mod wire exiting carpet 0609.JPG
Rating (1 votes)
File Size
202 KB
Dimensions
1280 x 960 pixels
Displayed
1947 times
BBCode
BBCode Full Size