Member Since: 31 Oct 2009
Location: Carluke
Posts: 2855
kidney wiper wrote:
Is that not the trafer box ECU behind that cover ?
Could be, all i know is, it got removed. Dried up and all pins cleaned and refitted.
Problem has since stopped so unless there's witchcraft* happening, i'm pointing the finger of blame at it.
*This is a possibility with LR product's that shouldn't be ignored. In loving memory of FA54WSK.
Rest well old friend, your work is done.
6th Feb 2013 9:44 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20853
kidney wiper wrote:
Is that not the trafer box ECU behind that cover ?
Member Since: 27 Aug 2012
Location: Orkney Islands
Posts: 597
Having similar sounding problems with my 05 plate TDV6 S. Got up yesterday morning to find that it was sitting on the drive with all the hazards flashing, doors constantly trying to unlock themselves, interior lights on and heater blower switching on and off.
Started the car and all faults went away but returned when I switched it off again. Started it again and left it running for half an hour before driving it to work (30 minute drive) and it seems to be ok now.
I wonder if it has done this before as a few weeks ago the battery went completely flat (less than 1 volt!). As the battery was original and on its way out I presumed that it had simply expired and got a new one. I have also blown 2 headlight bulbs in the last month (N/S and O/S). Will check behind the battery this weekend (when there is enough light!).Dave Neil
2018 Outlander PHEV
2005 Discovery 3 TDV6 S (went up in flames)
1972 Series 3 109 200tdi (@alfredthe109)
1972 MGB GT (in bits)
4th Dec 2013 9:36 am
A.J.M
Member Since: 31 Oct 2009
Location: Carluke
Posts: 2855
Checked that ecu behind the battery?In loving memory of FA54WSK.
Rest well old friend, your work is done.
4th Dec 2013 4:06 pm
orkneydave
Member Since: 27 Aug 2012
Location: Orkney Islands
Posts: 597
Not yet! Flew up to Shetland yesterday morning just after it happened an only fly back tomorrow. Will have to wait till the weekend when there is enough light.Dave Neil
2018 Outlander PHEV
2005 Discovery 3 TDV6 S (went up in flames)
1972 Series 3 109 200tdi (@alfredthe109)
1972 MGB GT (in bits)
4th Dec 2013 8:53 pm
Numpty
Member Since: 18 Aug 2012
Location: Bolton
Posts: 673
Years ago I had a Mondeo that had a "shelf" above the footwell at the base of the windscreen through which there was a hole for the heater to draw air via the pollen filter plastic housing. As Ford used a crappy foam seal which once wet rotted allowing water that had run off the windscreen past the seal making for a nice swimming pool in the passenger footwell.
Looking at the picture of the connector/ECU behind the battery it looks like a similar situation.
Do we know the route of the water i.e. off the corner of the wing or the base of the windscreen and how does that influence where to put sealant?
5th Dec 2013 12:09 pm
orkneydave
Member Since: 27 Aug 2012
Location: Orkney Islands
Posts: 597
Not had a chance to check for water at the ECU yet for being stuck in Shetland for a couple of days longer than planned due to the weather.
However, the fault did not appear the whole time I was away. It has however come back today. Not a problem when the ignition is on, but starts when the ignition is off (keys can be in or out). Fault goes away when brake pedal is pressed but comes back when lifted. And sometimes a park brake fault is displayed on the dash so think it must be something to do with the brakes. Brake lights are all working and the park brake module was replaced under warranty a couple of years ago, although I had to get Strathearn to release the cable and wind it back in last February. The saga continues!Dave Neil
2018 Outlander PHEV
2005 Discovery 3 TDV6 S (went up in flames)
1972 Series 3 109 200tdi (@alfredthe109)
1972 MGB GT (in bits)
8th Dec 2013 1:36 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20853
Low voltage on the red wire, at the brake pedal switch
Member Since: 27 Nov 2007
Location: Northern Rivers, NSW, Australia
Posts: 2050
Hi DM,
Great!
Best Wishes,
PeterThe Bearded Dragon
10th Dec 2013 11:00 pm
hutchy7
Member Since: 13 May 2017
Location: Dundee
Posts: 10
orkneydave wrote:
Having similar sounding problems with my 05 plate TDV6 S. Got up yesterday morning to find that it was sitting on the drive with all the hazards flashing, doors constantly trying to unlock themselves, interior lights on and heater blower switching on and off.
Started the car and all faults went away but returned when I switched it off again. Started it again and left it running for half an hour before driving it to work (30 minute drive) and it seems to be ok now.
I wonder if it has done this before as a few weeks ago the battery went completely flat (less than 1 volt!). As the battery was original and on its way out I presumed that it had simply expired and got a new one. I have also blown 2 headlight bulbs in the last month (N/S and O/S). Will check behind the battery this weekend (when there is enough light!).
This is exactly my problem! Orkneydave, did you ever solve this? Thanks in advance
13th May 2017 4:33 pm
djw113uk
Member Since: 11 Jun 2018
Location: Warwickshire
Posts: 29
Disco_Mikey wrote:
The red wire goes into a splice joint, which corrodes.
Splice into said wire, before it goes as far as the splice joint
Sorry to awaken such an old thread, but can you guide me as to where the red splice is please?
Mine is 2005 auto, but seems to have this hazard and locking fault that can be changed by pressing the brake pedal!
19th Nov 2023 12:43 am
ratrunner
Member Since: 20 Nov 2015
Location: cotswolds
Posts: 195
A.J.M wrote:
Update to lay this to rest.
The ECU had loads of water on it, the middle blue connector had loads of corroded pins so they were all cleaned up and the ECU dried out.
Thankfully that has worked so we had put some sealant on the connectors to stop water getting at them again.
Today we checked mine to see if I was going to have the issue. When we removed the cover my ECU was like new, no water Ingres signs anywhere. Sealant has been applied so it stays that way.
The ECU is behind a cover that's visible when you remove the battery. As pictured.
Click image to enlarge
So should anyone bother to use the search function in the future. This thread will show the likely issue and how to fix it.
Admin note: this post has had its images recovered from a money grabbing photo hosting site and reinstated
Is that the fuse box under the main battery ?
19th Nov 2023 4:32 pm
A.J.M
Member Since: 31 Oct 2009
Location: Carluke
Posts: 2855
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
