Member Since: 08 Jun 2021
Location: Derbyshire
Posts: 34
Suspension problems help required
Hi to all who read this.
I have another issue with the air suspension on my my06 disco 3.
Its currently sat on its bump stops and wont raise.
The switch on the centre console is showing the car as in off road mode, I have fault code C1 A20 64 - pressure increases too slowly when filling reservoir.
I've checked all fuses and relays and the wiring plugs in the nsf wheel arch all good.
When I clear the fault code the compressor runs for between 10secs to over a minute, the gallery pressure raises from 13.1psi to over 100psi before the compressor stops and the bong and amber light reappear, the car makes no effort to raise during this time, any help or thoughts much appreciated.
Would a replacement compressor be the route to go - just a thought.
31st May 2024 1:31 pm
rrhool
Member Since: 28 Aug 2014
Location: Norfolk
Posts: 4522
You could try cleaning the dryer, and replacing the desiccant before you splash out on a new compressor.Richard
D3 SE 2007. Triumph 2.5Pi 1973. Ferguson TEA20 1948.
Discovery 2 4.0 ES 2001- Gone
Discovery 1 300Tdi ES '95 - Gone
Range Rover Classic '79 - Gone
31st May 2024 2:04 pm
justmark
Member Since: 08 Jun 2021
Location: Derbyshire
Posts: 34
Hi, I did rebuild the compressor 3 years ago and replaced the dryer end cap and crystals, so its probably time to bite the bullet and try new.
31st May 2024 2:38 pm
justmark
Member Since: 08 Jun 2021
Location: Derbyshire
Posts: 34
Quick update, solved the problem by fitting a replacement air compressor, all good now,back to normal operation.
3rd Jun 2024 8:02 am
onetwentie
Member Since: 25 May 2020
Location: West Yorkshire
Posts: 105
Hi OP - Which compressor did you have was it the Hitachi? did you replace it with the same one?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
