TurCan
Member Since: 18 Dec 2011
Location: Toronto
Posts: 2
  
|
Hello all,
This is my first post, any help you can provide would be great.
My 2005 LR3's front right suspesion sits lower than others, as the rear left sits higher. This problem causes the truck pulls to right. There are no fault messages or lights on. Compressor seems working as i can hear the pumping noise when i start the truck... and although there are no obstacles under the truck, it often goes to the extended height mode, when i start the truck. Any idea what would be the problem?
Thank you!
Jim
|
 18th Mar 2012 5:10 pm |
|
|
DiscoDunc
Member Since: 08 May 2006
Location: Bristol
Posts: 16390
  
|
strange there are no fault codes but i would change the height sensors to start off with.
welcome 
EDIt - when you say not fault messages - do you mean no dashboard messages or have you have it plugged in to a diagnostic machine. if no, get that done and it may show up some fault codes. Duncan
-----------------------------------------------------
If I'd known I was going to be so thirsty this morning I'd have drunk more beer last night.
FFRR Autobiography 4.4 SDV8 MY17
D4 HSE MY13 SOLD
FFRR 3.6 Vogue TDV8 SOLD
D4 HSE MY10 SOLD
D4 SE TECH MY15 SOLD
D4 XS MY12 SOLD
D4 HSE MY10 SOLD
D3 HSE MY06 - Re-Cycled Worldwide
|
| 18th Mar 2012 5:18 pm |
|
|
TurCan
Member Since: 18 Dec 2011
Location: Toronto
Posts: 2
|
DiscoDunc wrote:strange there are no fault codes but i would change the height sensors to start off with.
welcome
EDIt - when you say not fault messages - do you mean no dashboard messages or have you have it plugged in to a diagnostic machine. if no, get that done and it may show up some fault codes.
Thank you for the reply,
I was suspecting the sensors too. I think after replacing them with the new ones, suspensions supposed to recalibrated by a Land Rover dealer. I mean i have to bring the truck to the dealer?
As the fault messages, i meant no dashboard messages. Actually, about a month ago it has been plugged in to a diagnostic machine because of check engine light, while this suspension problem persists. It came up with O2 sensors bank1 both side. They have been replaced with the new ones, but no other fault codes were found.
|
| 18th Mar 2012 6:21 pm |
|
|
SADISCOBOB
Member Since: 08 Oct 2010
Location: Alberton
Posts: 246
  
|
Get yourself an 'EAS 11d Tool' that is made in Canada. You then be able to do all work on your suspension including reset the height sensors - this latter may be all that is required. Info' on 11d tool is on this site - just search. Life always good with a Landy
2006 LR DISCO 3 4.4 V8 HSE
DISCO 1 2.8 TDi
DISCO11 TD5
RR CLASSIC 1980 3.5 V8
|
| 27th Sep 2012 10:16 am |
|
|
