Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Technical (D3)

battery / air suspension problems
Post Reply  Down to end
Page 1 of 1
whittymonster
 


Member Since: 01 May 2012
Location: monaghan
Posts: 6

Ireland 2005 Discovery 3 TDV6 SE Manual Buckingham BlueDiscovery 3
battery / air suspension problems

Hi All,

Just wondering if anyone can help with this problem. Yesterday after driving about 20 miles in my 2005 SE (106k miles) D3 i stopped at a filling station to fill up. After paying and returning to the vehicle when i tried to start it the hazard lights started flashing, central locking closed and unclosed a couple of times and the engine wouldn't start. it would not even tick over. There was a strange smell coming from the bonnet in the vicinity of the battery, kind of like a smell you would get if doing some soldering.

Stranded on the forecourt (5.45pm in the evening!!) i called an emergency breakdown service who were able to jump the battery (which is no greater than 3 years old) and get me moving. however the following warning lights came up on the dash: break warning (red), dsc / traction control, air suspension, abs (all amber). Also "HDC system fault suspension lowered" message. The vehicle is now permanently locked at the lowered suspension. i brought the vehicle to a local garage where they checked the battery. they told me that the battery needed to be recharged fully and that this would not be possible by just driving alone.

fearful that the battery my drain again I borrowed a new battery from a car factor but the warning lights and lowered suspension still remain. This morning i brought the vehicle to a local garage to see if they could run a diagnostics (no T4 equipment as no LR dealer nearby) but he came up with the following fault codes:
u0416 invalid data recieved from vehicle dynamics control module
u0401 invalid data recieved from engine control module powertrain control module
u1A13 lost communication with all terrain control module
c1A77 valve relay supply circuit

So what I'm wondering is:
- how would the power in my battery discharge so soon after the vehicle had been driving
- what could the problem potentially be?
- is there any way for me to manually reset the vehicle to get the air suspension operating again?
- is it safe for me to continue driving the vehicle at the lowered suspension setting (seems to be a fair bit of heat coming from underneath the front wheel arches)?
- Would a dead / faulty battery cause all of the warning lights listed above to come on?

A lot of questions I know but would really appreciate any advice you have to offer.

Thanks

Confused
  
Post #9720871st Sep 2012 2:42 pm
View user's profile Send private message View poster's gallery Reply with quote
sarumlight
 


Member Since: 06 Nov 2008
Location: Off the Plain
Posts: 1592

United Kingdom 2008 Discovery 3 TDV6 HSE Auto Tonga GreenDiscovery 3

My guess would be the alternator isn't charging properly?
  
Post #9720961st Sep 2012 2:59 pm
View user's profile Send private message View poster's gallery Reply with quote
Disco_Mikey
 


Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20841

Scotland 2005 Discovery 3 TDV6 HSE Auto Cairns BlueDiscovery 3
Re: battery / air suspension problems

whittymonster wrote:
Hi All,

Just wondering if anyone can help with this problem. Yesterday after driving about 20 miles in my 2005 SE (106k miles) D3 i stopped at a filling station to fill up. After paying and returning to the vehicle when i tried to start it the hazard lights started flashing, central locking closed and unclosed a couple of times and the engine wouldn't start...


Sounds like a can-bus issue, preventing the car from starting.

A flat battery would not cause this, and is more than likely just sheer coincidence the car started with a jump start

Once the car is up and running again, the suspension should function properly until, or if, the fault returns again.
All the warning lights have come on because each ECU on the car cannot communicate with each other, and logs faults.

Unfortunately, tracking down a can-bus wiring issue can be a very long and laborious procedure.

Has the car had any work done recently? It may be something as simple as a loose connection somewhere
 My D3 Build Thread

TDV8 Retrofit Build Thread 
 
Post #9720971st Sep 2012 3:00 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
whittymonster
 


Member Since: 01 May 2012
Location: monaghan
Posts: 6

Ireland 2005 Discovery 3 TDV6 SE Manual Buckingham BlueDiscovery 3

Disco Mike,
the most recent work carried out was replacing the condenser for the air conditioning system.

does anyone know if it is still safe to drive the vehicle as my nearest landrover dealer is some distance away???

cheers
  
Post #9721531st Sep 2012 6:04 pm
View user's profile Send private message View poster's gallery Reply with quote
Sean007
 


Member Since: 23 Dec 2019
Location: Lincolnshire
Posts: 28


did you ever fix the problem having similar problems
  
Post #210862726th Dec 2019 8:26 pm
View user's profile Send private message View poster's gallery Reply with quote
ambrown31
 


Member Since: 17 Aug 2013
Location: United States
Posts: 12

United States 2005 LR3 4.4 V8 HSE Auto Java BlackLR3
C1A77 Valve relay supply circuit

I am getting the C1A77 Valve relay supply circuit code. Did you figure that one out?
  
Post #216424329th Jul 2020 2:35 am
View user's profile Send private message View poster's gallery Reply with quote
Fesmo
 


Member Since: 04 Jun 2024
Location: York
Posts: 2

England 2005 Discovery 3 TDV6 HSE Manual Santorini BlackDiscovery 3

Hello, whittymonster and/or sean007, I have the exact same issue at the moment, I would love to know if and how you both fixed the issue, any help or advice would be hugely appreciated.

Hopefully you can help me and are still active in this site
  
Post #23704614th Jun 2024 9:49 pm
View user's profile Send private message View poster's gallery Reply with quote
loanrangie
 


Member Since: 18 Jun 2017
Location: Melbourne
Posts: 700

Australia 2008 Discovery 3 TDV6 SE Auto Stornoway GreyDiscovery 3

What the OP described are classic symptoms of a can-bus/dash cluster failure, so either cracked solder joints on the cluster or a wiring issue on the can-bus network most commonly the rear left connector that sits on the chassis just behind the left rear wheel.
  
Post #23704685th Jun 2024 3:31 am
View user's profile Send private message View poster's gallery Reply with quote
Fesmo
 


Member Since: 04 Jun 2024
Location: York
Posts: 2

England 2005 Discovery 3 TDV6 HSE Manual Santorini BlackDiscovery 3

Tha KS for the response!

Is this a complicated/expensive issue to fix or repair? Should I even attempt to fix it as the vehicle is currently at 215k miles....

I'm aware discos aren't usually cheap to fix and Dont want to open a black pit of costs on a vehicle so old, although it was driving and performing perfectly Up until this issue.
  
Post #23704695th Jun 2024 6:02 am
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site