Member Since: 02 May 2011
Location: Rochdale - Manchester
Posts: 176
Converting to a LED Trailer Board
Got hold of some 12v Hamberger type LED's Lamps which i am planning to use on my trailer board.
I have the usual crappy trailer lamps on my board so have re-wired and replaced them with the LED'S.
Before i plug the thing in my Disco 4 7 pin socket do you think i will need any resistors, or is the Disco LED ready
Cheers2007 RS4 Avant
Gone just when it was looking so good - 2010 HSE, Nara Bronze + RLD dogs danglies Sump PLate & spare wheel protector + Side Steps + Wiggs Remote Climate + 20" Genuine Stormers + Cooper LTZ Bad Boys + Landmark Black Gloss Grille & Vents + Black Gloss Door Handle Skins + Cubby fridge + Sliding Rear Loadspace
12th Apr 2012 2:52 pm
ljason286
Member Since: 11 Dec 2007
Location: Barham
Posts: 174
How did you get on with the amber indicator bulbs in ledRemote time climate
Surround cameras
Privacy glass
Tow bar storage
Side steps
Chubby cooler
Genuine LR rubber mat set
Genuine 2nd row seat covers
4 x black wheel centre caps
12th Apr 2012 7:31 pm
SHARKYSHARKS
Member Since: 20 Dec 2008
Location: Saddleworth Oldham
Posts: 1954
Hope you got some good discount at a reputable truck factors Roylance MY18 D5 HSE LUX😎
MY12 Freelander SD4 HSE
44 Tonne 12 Litre 6x2 Scania T cab (Current)
Freelander 1 (Wrote off 😫)
Ex D1
Ex D2 GS
Ex V8 D2 GS
Ex D3 S
Ex D4 GS
Club skip ya lockers !!!
Club BAS remote heater !!
Club Duratrac
Club Phillips DRL
Club Prospeed Rack Mk 1
Club Prospeed Rack Mk 2
Club Sankey
Club RLD spare wheel protector
12th Apr 2012 7:55 pm
ROYLANCE
Member Since: 02 May 2011
Location: Rochdale - Manchester
Posts: 176
ljason286 wrote:
How did you get on with the amber indicator bulbs in led
HIDS4U said he had some in development with an overseas supplier but I Don't think the bulbs will ever be produced in amber LED -there just ain't enough vehicles using that bulb in fact only the D4 using amber I think.
The only way I can see anyone getting an amber LED in the D4 indicator is to cut out the bulb holder part and glue in the holder cut out from a BMW or VW indicator lamp and use a PY24W Amber LED which is readily available.
It can be done but unless you can pick some lamps cheap to butcher then it's an expensive experiment.
Anyone changed the side repeaters to LED yet ??2007 RS4 Avant
Gone just when it was looking so good - 2010 HSE, Nara Bronze + RLD dogs danglies Sump PLate & spare wheel protector + Side Steps + Wiggs Remote Climate + 20" Genuine Stormers + Cooper LTZ Bad Boys + Landmark Black Gloss Grille & Vents + Black Gloss Door Handle Skins + Cubby fridge + Sliding Rear Loadspace
12th Apr 2012 8:59 pm
disco4x4au
Member Since: 19 Jan 2006
Location: Perth
Posts: 409
If you want the trailer stability program to activate (and deactivate your rear parking sensors), you'll need a resistive load across one of the indicator circuits.
Cheers,
Gordonex - 2006 D3 TDV6 SE, silver, with lots of stuff - R.I.P.
ex - 2009 D3 TDV6 SE, silver, had lots of stuff too!
Now - 2010 RRS 3.0 TDV6, rimini red, 18" rims + Cooper LTZ, rear eLocker, Spider tuning box, GOE protection plates and rock sliders, GOE 3way shortened rods.
13th Apr 2012 12:02 am
ROYLANCE
Member Since: 02 May 2011
Location: Rochdale - Manchester
Posts: 176
disco4x4au wrote:
If you want the trailer stability program to activate (and deactivate your rear parking sensors), you'll need a resistive load across one of the indicator circuits.
Cheers,
Gordon
Sorry Gordon
Not been able to try my converted LED board out cause the cars been in the dealers for 2 weeks.
Now I've got the beast back I've got it wired up and running.
All the lights work perfect except for the trailer indicator symbol on the dash, but since I'm only using it for bikes and LED's are far more reliable I think i can manage.
The only thing I haven't tried yet is reverse gear before the car knew a trailer was plugged in and automatically shut the bleepers off
Admin note: this post has had its images recovered from a money grabbing photo hosting site and reinstated 2007 RS4 Avant
Gone just when it was looking so good - 2010 HSE, Nara Bronze + RLD dogs danglies Sump PLate & spare wheel protector + Side Steps + Wiggs Remote Climate + 20" Genuine Stormers + Cooper LTZ Bad Boys + Landmark Black Gloss Grille & Vents + Black Gloss Door Handle Skins + Cubby fridge + Sliding Rear Loadspace
28th Apr 2012 6:08 pm
DRD
Member Since: 09 Apr 2012
Location: Wagga Wagga
Posts: 7
Has anyone have a pin out for the white covered plug?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
do you think i will need any resistors, or is the Disco LED ready
before the car knew a trailer was plugged in and automatically shut the bleepers off
