| Home · FAQ · New Posts · My Posts · PMs · Search · Members · Members Map · Groups · Profile · Donate ·
Log In
|
- You are currently viewing DISCO3.CO.UK as a guest - Register to take part or Log In
Paul Ian
Member Since: 24 Jul 2011
Location: North London
Posts: 107
  
|
Hi could anyone please advise on slight knocking noise from front of vehicle only when braking mainly under load, feels like inner track control arm bushes, any info greatly appreciated 07 Disco 3.
Regards
Paul.
|
 12th Nov 2011 5:19 pm |
|
|
character
Member Since: 31 Dec 2007
Location: wiltshire
Posts: 5781
 
|
paul could be all manner of things, brake caliper, steering rack, steering rack tie rods, upper bushes, lower bushes coudl even be further back rear ball joints, yer not going to find a solution to it here....need to get him in to a dealer coz yer not going to be able to second guess from a forum 
|
| 12th Nov 2011 6:20 pm |
|
|
Paul Ian
Member Since: 24 Jul 2011
Location: North London
Posts: 107
|
Many thanks for the feedback I am going to get it checked just wondered if there was a common fault on the suspension wishbone bushes like on a lot of vehicles.
Regards
Paul
|
| 12th Nov 2011 6:26 pm |
|
|
SADISCOBOB
Member Since: 08 Oct 2010
Location: Alberton
Posts: 246
 
|
There is a very common problem.....or two. If 'clonk' when you apply heavy brake when going very slowly - likely to be lower rear bush failure. or lower ball joint failure.
I had this and have just replaced OEM lower wishbones complete. When the old wishbones came off I found both the above had 'gone' on both wishbones! Very poor for 100 000 klm of tar driving (never off road).
NOTE : Ref DECEMBER LRO Mag - Disco3 Project part 9 - Changing front wishbones : When reassembling it states "Airspring is left unbolted at this stage"! TIP : fit lower wishbone with loose bolts, loose bolt through airspring, fit stub axle carrier and with stub axle through carrier ( othwise you won't get it in later ), raise whole assembly on jack and fit to top wishbone. Then proceed. IF YOU LEAVE AIRSPRING UNTIL CONNECTED TO TOP WISHBONE YOU WILL FIGHT THE AIRSPRING FOR A COUPLE OF HOURS BEFORE GIVING IN AND STARTING AGAIN!!!!
I have just had the wheel alignment done after setting to "tight tolerance" and I now have a different wagon - it really is a limo now.
All the best everyone Life always good with a Landy
2006 LR DISCO 3 4.4 V8 HSE
DISCO 1 2.8 TDi
DISCO11 TD5
RR CLASSIC 1980 3.5 V8
|
| 22nd Nov 2011 12:08 pm |
|
|
Paul Ian
Member Since: 24 Jul 2011
Location: North London
Posts: 107
|
Hi SADISCOBOB and many thanks for the usfull reply, I had thought it felt like track control arm bushes can I enquire what the you think of the patterns arms are like as there are lots available on the site and internet?
Regards
Paul.
|
| 22nd Nov 2011 1:25 pm |
|
|
|
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
|
|
DISCO3.CO.UK is independent and not affiliated to Land Rover.
