Member Since: 29 Nov 2007
Location: Berlin
Posts: 263
After reading this, just checked mine, whoa, looked like a carbon mole hill, completely plugged up anyway, cleaned it as per most on here, bit of WD40 and the eye of a needle for the inners and then went for a check ride down the Autobahn
2007 (MY2008) 93K kms, TorqTune remap from TFC
Result, speed increasing had to back off when a truck pulled out on me another 10 kmh in there somewhere I think.
MY2008, Java Black TDV6 HSE, Alpaca with straight grain Wood, 19" alloys, fully loaded with all the toys
Discovery 3, you know it makes sense.
Last edited by Berlin Warrior on 15th May 2011 3:11 pm. Edited 1 time in total
15th May 2011 3:04 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 72931
Wow, 190kph/120mph!!
15th May 2011 3:09 pm
Berlin Warrior
Member Since: 29 Nov 2007
Location: Berlin
Posts: 263
DSL wrote:
Wow, 190kph/120mph!!
........and still pulling like a Torq Tune train Knowledge & Reason - the arch enemy of faith
MY2008, Java Black TDV6 HSE, Alpaca with straight grain Wood, 19" alloys, fully loaded with all the toys
Discovery 3, you know it makes sense.
15th May 2011 3:11 pm
Dave T
Member Since: 03 Jul 2009
Location: Glasgow
Posts: 6903
Well it does seem to have made a difference, definately appears to be a bit more responsive and the range on the tank has increased overall by about 80 miles, will see mpg when I top up on Fuelly, or is it all in the imagination? Joined the BMWX5 45e group
1994 Defender 90
2015 RRS Corris Grey/Black roof
2016 D4 Graphite Santorini Black
2012 D4 XS Orkney Grey
2005 D3 S Maya Gold
as a couple people have called me requesting new MAP sensors, due to, umm faulty cleaning
i have looked into them and realised the complete egr valve is cheaper than the MAP sensor alone
Map Sensor
1316126
£166.54 retail
Complete manifold/egr with MAP sensor installed
LR007124
£144.11 retail
no figure.................TLO has left the building.......
I no longer work for a Landrover Dealer
My little chilli sauce business http://www.thechillees.co.uk
if you would like to order anything just give me a shout
16th May 2011 9:12 am
AndrewW
Member Since: 06 Aug 2007
Location: Saddleworth
Posts: 2302
First long run - definitely 2-3 mpg better - definitely smoother, definitely a bit more poke.
But is it the clean MAP sensor , the new tyres*** or the new ashtray assembly???
***the new ATs - couldn't get any more AT2s apparently banned by EU drive-by noise regulations; new ATs all round. Lovely tyres, smoother drive but the drive-by noise as reflected by the M62 concrete crash barrier is WORSE 2006 D3 finally swapped for a 2016 D4 Graphite in Graphite grey. No mods
16th May 2011 9:13 am
Gareth Site Moderator
Member Since: 07 Dec 2004
Location: Bramhall
Posts: 26750
Nick, surely you mean the plastic chamber with the egr butterfly and the MAP sensor in it? Not the EGR valve itself
Nick, surely you mean the plastic chamber with the egr butterfly and the MAP sensor in it? Not the EGR valve itself
yep tis still early and not had me coffee yet TLO has left the building.......
I no longer work for a Landrover Dealer
My little chilli sauce business http://www.thechillees.co.uk
if you would like to order anything just give me a shout
16th May 2011 9:26 am
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 72931
Weird thing re MAP sensor change for me was after cleaning it big improvement, then had remap applied and mpg fell 10%ish (before cleaning was -20%). Changed MAP sensor to nice new one supplied by St Nick and she's back to normal and mpg is where it should be for given type of driving.
Now leads to me thinking. I don't think there is a placebo effect, too many peeps reporting hard numbers being improved and with Berlin Warrior approaching V1 speeds it deffo seems to be doing something. As the MAP sensor governs fuel supply it makes sense when that plays up it's only going to increase mpg, we don't get lucky enough to improve things the other way. Is anyone at LR aware of this? Taken over the small sample above there must be tens or hundreds of thousands of car's affected out there. Apart from Nick, every time I mention it to a dealer or techie they either glaze over or have no idea what I'm talking about. Obviously it's not on the service schedule, it's not of any interest. I can be cynical in that changing more expensive parts is more attractive, but it's probably genuinely having no idea what is happening. I doubt LR themselves are interested in another thing on the service schedule, if they even thought there was an issue. The air filter is only changed every 45k, no way they are going to add annual checks to MAP sensors. If LRCS are watching these type of sites they would realise that there were issues, then dealers would be aware of things. Interesting thread on The Dark Side http://www.rrsport.co.uk/forum/topic22140.html?highlight= where LR Aus basically don't give a stuff re problems that aren't on their radar, to the point of hanging up on their customers, they have seriously lost the plot. Wonder if same here.
These ongoing problems for the last year (loads of ESF shutdowns, poor performance and dire fuel consumption) are part of the reasons I'm picking up a nice new Beemer tomorrow, not a D4 that I should have been buying. The line of 5 LRs as family car for us has come to an end.
Any way, where was I?? Keep checking your sensors peeps, together we'll save Da Planet.
16th May 2011 10:44 am
Berlin Warrior
Member Since: 29 Nov 2007
Location: Berlin
Posts: 263
Having done my flying "apprenticeship" on turbo charged piston engines (Pratt & Whitney Twin Wasp Radials rock), it amazes me that the TDV6 seems rather indifferent and largely insensitive to MAP. on a turbo charged aircraft engine, MAP is the parameter that is used to set engine power, ignore its limits at your engines life peril.Knowledge & Reason - the arch enemy of faith
MY2008, Java Black TDV6 HSE, Alpaca with straight grain Wood, 19" alloys, fully loaded with all the toys
Discovery 3, you know it makes sense.
16th May 2011 11:26 am
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 72931
Also surprised me that all was well after cleaning til remap applied, poss general use has a wider set of acceptable parameters, remap needs a tighter set that was outside those it was putting out.
Or co-incidentally the sensor failed when TorqTune was reapplied but doubt that. Anyone want a slightly (80k) used sensor??
16th May 2011 11:41 am
DG Site Moderator
Member Since: 12 Dec 2005
Location: The Gaff
Posts: 50971
Del....explain to my brain (we could be here sometime ).....as long as there is a hole surely it should be able to read the pressure ....no? If that is the case then the peeps who have had theirs completely covered with the gunk should therefore be the only ones with a possible sensor reading issue and therefore notice a change in performance perhaps 21 year LR veteran > D2 GS 2003 > D3 S 2006 > D3 HSE 2009 > D4 HSE 2013 > D4 HSE 2015 > D5 HSE 2018 > DS HSE R-Dynamic P300e 2021
16th May 2011 11:57 am
Berlin Warrior
Member Since: 29 Nov 2007
Location: Berlin
Posts: 263
DG wrote:
Del....explain to my brain (we could be here sometime ).....as long as there is a hole surely it should be able to read the pressure ....no? If that is the case then the peeps who have had theirs completely covered with the gunk should therefore be the only ones with a possible sensor reading issue and therefore notice a change in performance perhaps
Yes, if it's measuring static and not dynamic pressure (which I assume it is). Although if it's partially blocked the sensors response time may well be affected.Knowledge & Reason - the arch enemy of faith
MY2008, Java Black TDV6 HSE, Alpaca with straight grain Wood, 19" alloys, fully loaded with all the toys
Discovery 3, you know it makes sense.
16th May 2011 12:01 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 72931
DG, I'd agree except mine was only reasonably gunked, hole still there but as soon as I cleaned it the difference was immediate. In a static environment, no airflow, it would measure correctly with gunk on body but hole clear. Where there is airflow over the sensor that flow would be turbulent coz of the oil and not laminar so would/could change the reading due to the different way the air is moving. Comparison with iced up sensor tubes on aircraft, the hole is clear but the reading is wrong as the airflow is turbulent.
SWMBO's just reminded me i'm not an internationally renowned expert on MAP sensors, oh how cruel she can be!!
16th May 2011 12:08 pm
DG Site Moderator
Member Since: 12 Dec 2005
Location: The Gaff
Posts: 50971
Just wondered as the reports back on a performance increase seem a bit vague on the circumstances TBH ...maybe a new poll del ? ...have to say though that a clean one must be better than a dirty one 21 year LR veteran > D2 GS 2003 > D3 S 2006 > D3 HSE 2009 > D4 HSE 2013 > D4 HSE 2015 > D5 HSE 2018 > DS HSE R-Dynamic P300e 2021
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum