Sticky
Member Since: 27 Aug 2008
Location: nottingham
Posts: 15
  
|
| Help, throttle does not work properly |
|
Hello,
This is my 1st post and i hope someone can help me out.
Got into the car tonight started it up and the throttle seems to be not connected to the engine.
sometimes it does nothing even when fully depressed, then it will slowly start to pull away then all of a sudden it will fly off as if you have floored it.
when driving the engine does not respond to the throttle position.
Help please need it for work tomorrw.
David.
|
 6th Dec 2010 10:20 pm |
|
|
jkp
Member Since: 16 Sep 2005
Location: Living among Bawbags
Posts: 4528
|
EGR valves .... plenty info on here about them
|
| 6th Dec 2010 10:22 pm |
|
|
bigtam64
Member Since: 19 Nov 2009
Location: Leeds
Posts: 192
 
|
Agree sticking AGR valves will be replaced if under warranty if not blanking kits are readily available Weekends are to short
Egr valves removed
|
| 15th Jan 2011 4:16 pm |
|
|
Achung
Member Since: 17 Sep 2013
Location: Philippines
Posts: 3
 
|
Hi, after having been to the shop for multiple faults due to clogged drainage issue..... Finally all faults where solved mostly connections and reprograming. Now the lr3 doesn't want to go pass 70 kph but no fault came out. The engine is great and transmission shifts well. Can anyone suggest any possible solution to this? The shop is still experimenting on it since it's the first time they have experienced it. Btw the shop is the land rover shop here in Manila, Philippines.
|
| 17th Sep 2013 5:37 am |
|
|
ifx
Member Since: 19 Jun 2013
Location: Cape Town
Posts: 69
|
bigtam64 wrote:Agree sticking AGR valves will be replaced if under warranty if not blanking kits are readily available
My EGRs were shot, had to use low range to get out the driveway when the engine was cold. Blank the bug  rs...
|
| 17th Sep 2013 2:54 pm |
|
|
Achung
Member Since: 17 Sep 2013
Location: Philippines
Posts: 3
|
No black smoke and has power ....... Restricted speed but no fault. What is wrong? Anyone can suggest the next move.....
|
| 18th Sep 2013 6:38 am |
|
|
gazdiver
Member Since: 04 May 2011
Location: Where the Pork Pies and Stilton Run Free
Posts: 324
|
Check your Turbo actuator i assume its a diesel you have
plenty of stuff on here if you search for turbo actuator faults if they are a LR dealer though surely they have got the fault codes ??
if you have can get the codes advice from forum could be more specific rather than poke and hope
|
| 18th Sep 2013 7:55 am |
|
|
Achung
Member Since: 17 Sep 2013
Location: Philippines
Posts: 3
|
Actually it's petrol. My sense is the connectors of the wire harness to the sensors to the transmission. I had the guys take a look at that first. They are all in a quandary on why there are no faults showing and yet the thing is on limp mode... Had the ithing reset to be sure none of the old faults are still in the memory but no luck... I am running out of option, maybe you guys can make any other suggestions.
|
| 18th Sep 2013 2:46 pm |
|
|
Globetrotter448
Member Since: 21 Mar 2017
Location: Londonderry NSW
Posts: 1822
|
There is a controller on the accelerator pedal, this in turn operates the butterfly in the throttle control.
I would remove the plastic housing coming from the air box (MAF sensor in this pipe) and then with ignition on but engine not running and see if butterfly opens fully. This butterfly is known to get "gunged up" and may need cleaning. It is also good to clean MAF sensor as well. If it works okay then check fuel pressure - schrader valve
|
| 21st Jan 2018 7:32 am |
|
|
Glenn of Belgium
Member Since: 29 Jul 2013
Location: Zeebrugge
Posts: 108
|
Ar there any issues by removing the butterfly valve with not blanked egr's???
I would not remove the servo motor that turns the butterfly...
So i think the air intake will be open 100% always??
|
| 10th Jan 2019 11:03 am |
|
|
Globetrotter448
Member Since: 21 Mar 2017
Location: Londonderry NSW
Posts: 1822
|
That butterfly valve is what controls the engine speed - removing totally is not an option
|
| 10th Jan 2019 9:28 pm |
|
|
Glenn of Belgium
Member Since: 29 Jul 2013
Location: Zeebrugge
Posts: 108
|
Don't think so or, is a Diesel engine...
The butterfly valve chokes the inlet from air filter to inlet manifold for getting the recirculation of exhaust gassen in to the inlet manifold...
What i would think and try to do is fully open air flow at all times by removing it (and then blank the egr valves later on when software can be done at the end of this month...)
?no?
VEHICLE:
LR3 Discovery - MY2007 - TDV6 2.7L diesel
unblanked egr's
Last edited by Glenn of Belgium on 11th Jan 2019 11:03 am. Edited 1 time in total
|
| 11th Jan 2019 9:20 am |
|
|
Globetrotter448
Member Since: 21 Mar 2017
Location: Londonderry NSW
Posts: 1822
|
your vehicle
|
| 11th Jan 2019 10:26 am |
|
|
discoverybrazil
Member Since: 07 Aug 2018
Location: sao paulo
Posts: 102
 
|
| Re: Help, throttle does not work properly |
|
Sticky wrote:Hello,
This is my 1st post and i hope someone can help me out.
Got into the car tonight started it up and the throttle seems to be not connected to the engine.
sometimes it does nothing even when fully depressed, then it will slowly start to pull away then all of a sudden it will fly off as if you have floored it.
when driving the engine does not respond to the throttle position.
Help please need it for work tomorrw.
David.
check your MAF LR3 ON ROAD ONLY
|
| 11th Jan 2019 4:01 pm |
|
|
Glenn of Belgium
Member Since: 29 Jul 2013
Location: Zeebrugge
Posts: 108
|
Hi Discovery Brasil,
I have stll the same with my LR3 2007... is it also a bit as if the special program of the TR is in grass gavel snow???
After a while, everything seems normal and car is driving normal with full power...
I already cleaned the MAF, replaced the MAP with a new one and so on.
I also drove the car with butterfly valve open and butterfly motor disconected from valve with only the electrics connected...
Sympton was stil there, so i asume its not directly a egr problem also because engine had full air supply...
I'm also looking for a solution... maybe we can keep in touch and follow up each other
Regards Glenn
|
| 13th Jan 2019 10:54 am |
|
|
