Member Since: 27 Jan 2008
Location: Oxon
Posts: 708
Now with tints and full length roof rails...
Just got in, sun was out, picture had to be taken...
8th Oct 2009 2:49 pm
PaulP
Member Since: 04 May 2007
Location: Barcelona
Posts: 4317
That looks stunning Martin
I have to say that I think the 19" wheels sit much better on the D4 than the 20" 2006 Discovery 3 TDV6 SE AutoBuckingham Blue 2007 Golf GT DSG
8th Oct 2009 2:56 pm
ThatMartinChap
Member Since: 06 Nov 2007
Location: Deepest Darkest Berkshire
Posts: 696
looking good - I like the full length rails.
Daft question - are they functional or just cosmetic ? I assume they're functional and you need them for the canoes ?Also Gone : MY14 D4 SDV6 HSE : Barolo Black + Almond
Sadly Gone : MY08 D3 TDV6 HSE : Stornoway + Alpaca + Privacy + BAS Remap
8th Oct 2009 2:59 pm
MartinR
Member Since: 27 Jan 2008
Location: Oxon
Posts: 708
I jolly well hope they're functional - though I do think they look pretty 8) anyway...
The slots run to just behind the front 'foot' so it should allow me to get the boat a couple of feet further forward, reducing the rear overhang somewhat. Just have to rig something to make sure I don't scratch the top of the boot lid when loading - may see if I can get one of the rollers you see on the back of builders vans!
8th Oct 2009 3:11 pm
John C
Member Since: 28 Aug 2007
Location: East Yorkshire
Posts: 3292
Looks fantastic!
Shame about that ding on the drivers door....
...I'm just jealous 2020 SDV6 D5 HSE, Carpathian Grey +
2022 Tesla Model Y LR... almost Carpathian Grey
Previously : 2005 TDV6 SE Auto, Cairns Blue (288K) - ours for 16 years
8th Oct 2009 3:19 pm
Bill Wright
Member Since: 03 Nov 2007
Location: Glorious Devon
Posts: 3254
Martin
Cost of full length rails? Are they extenders or instead of the normal length.
Bill WrightNever take life too seriously. Nobody gets out alive anyway.
D4 SDV6 SE Tech Kaikoura Stone MY15.
8th Oct 2009 3:45 pm
MartinR
Member Since: 27 Jan 2008
Location: Oxon
Posts: 708
They're full length and replace the standard rails. PM Nick (The Large One) for latest forum price, mine were supplied and fitted as part of the deal so hard to say what they cost...
Have you looked at www.Kari-tek.co.uk. They have an excellent system for loading kayaks onto high sided vehicles ???
I'd be interested to know how you get on with the extended rails as the rear overhang with pucker sea kayaks is too much.
The cross bars need to be further forward to balance the kayaks correctly without causing any damage.
Have you also thought of putting a hydro glide (thule) on the rear bars to help with the loading of the canadian??
11th Oct 2009 9:20 am
MartinR
Member Since: 27 Jan 2008
Location: Oxon
Posts: 708
Loading the boats is pretty easy. I've got 135cm cross bars (instead of the standard 120s) to leave room for j-bars on each end. The kayaks then just lift straight onto the j-bars (OK, it helps that I'm 6 foot for that bit!) while the canoe loads from the back, with the j-bars acting as guides to stop it sliding off either side. The kari-tek stuff looks neat, but I suspect that loading the canoe would actually be harder than with my set up - it certainly won't be a one man job - and then there's the small matter of lifting 60-70 kg of boats in one hit...
The only problem with having the bars further forward is going to be that I won't be able to rest the boat on the back bar and the ground - hence looking at one of the rollers you see on the back of builders' vans for loading up 8x4 sheets.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
