measure the thickness of the bracket, washer and length of the tube and twice the bore of the tube and add them all up
"I know that you believe that you understood what you think I said, but I am not sure you realize that what you read is not what I meant"
6th May 2009 9:20 pm
NeVeTaS
Member Since: 25 Mar 2009
Location: Eürope
Posts: 137
Don't have the tube either. Got everything else though
If no one come back to you the only help I can offer is
1/ to find a drill bit a tad smaller than the hole in the bracket.
Fit both brackets to the guard and position reasonably in the right place.
Push the dill bit chuck end first through the bracket, mark it (pencil)level with the guard side of the bracket, remove and measure, repeat on the other side and halve it (get it equal) then knock 5mm off to allow for the washer, bracket and a bit of tension.
2/The hole in the bracket will be clearance for the bolt, so the tube will be the same.
3/The bolt will be the first dimension 1/ plus twice 2/
"I know that you believe that you understood what you think I said, but I am not sure you realize that what you read is not what I meant"
6th May 2009 9:33 pm
NeVeTaS
Member Since: 25 Mar 2009
Location: Eürope
Posts: 137
Good idea
Many Thanks
6th May 2009 9:36 pm
daveshephard
Member Since: 07 May 2009
Location: Bristol
Posts: 2
I can measure when I get home if you haven't found out - do you a swap - any chance of PDF ing the instructions - I have everything but those !!
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum