Juliat
Member Since: 28 Oct 2008
Location: Sydney
Posts: 38
  
|
| second row seats removal, torque for torx bolts |
|
Have removed the middle seat of the 2nd row, in order to put the water containers on the floor. Having checked the depth below have put the torx nuts back in the holes. When we return and reconfigure the vehicle do the torx nuts have a torque setting? (if that is the correct terminology).
I did consider putting shorter nuts in the vacant holes but was concerned about damaging the threads.
Julia
|
 26th May 2009 12:26 pm |
|
|
IanR
Member Since: 28 Apr 2007
Location: Daleys Point
Posts: 99
 
|
We also remove all 2nd row seats for extended trips - plug unused holes with 'arrow head' shaped high density foam (pushed in from inside) then tape over with duct tape - so far no dust no water into cab.
After putting seats back I just tightened bolts as firm as I could by hand - can't see why they would need specific torque? 'S' TDV6, Air suspension, Terrain Response, Active rear diff, Safari Snorkel, Opposite Lock rear wheel carrier, OL drawer system, Cargo Barrier, Dual batteries with Rotronics isolator, GME 3440 UHF. Codan NGT HF, Asus UMPC running TrackRanger. Cooper LT245/70R17 STTs when off-road. Tow Ultimate off-road camper.
|
| 26th May 2009 1:14 pm |
|
|
catweasel
Member Since: 05 May 2006
Location: Bundaleer
Posts: 4805
|
40 Nm. same for third row also.
|
| 26th May 2009 1:31 pm |
|
|
Juliat
Member Since: 28 Oct 2008
Location: Sydney
Posts: 38
|
Thanks
Julia
|
| 26th May 2009 9:33 pm |
|
|
