Landylad
Member Since: 23 Dec 2008
Location: Aberdeenshire
Posts: 366
|
wiggs wrote:dark.soul999 wrote:Hi, when a fault is stored in FBH is not possible to clear without IDS (or other diagnostic tool).
The error lockout mode can be cleared using T4, or by disconnecting the battery power supply
(connector C0926) for a minimum of 10 seconds.
Hey Wiggs.... which one is this?
Cheers. If in doot, flat oot!!
|
10th Feb 2009 9:51 pm |
|
|
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14372
|
The one i mentioned on the first page of this thred ..2 pin one with purple wire ( power connector ) G4 Gone ...but not forgotten
|
10th Feb 2009 9:58 pm |
|
|
Landylad
Member Since: 23 Dec 2008
Location: Aberdeenshire
Posts: 366
|
Ah, ok Wiggs... that's the one I was disconnecting (eventually, after disconnecting the other two to start). Incidentally, I the connector pulling it off and had to Areldite it back on again I don't think that's gonna do me any favours.
In any event, the disconnect didn't return any remedy, although I'm not doubting that it works for some.
What's T4? If in doot, flat oot!!
|
10th Feb 2009 10:25 pm |
|
|
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14372
|
Landrover computer the dealer uses G4 Gone ...but not forgotten
|
10th Feb 2009 10:41 pm |
|
|
Landylad
Member Since: 23 Dec 2008
Location: Aberdeenshire
Posts: 366
|
I presume a reset of the FBH can only be done by a LR dealer or can anyone with a computer analyser do it? If in doot, flat oot!!
|
10th Feb 2009 10:46 pm |
|
|
sopjas
Member Since: 31 Dec 2008
Location: Its never Dull in Hull
Posts: 280
|
If your worries that the FBH is faulty any webasto dealer can unplug land rover wiring and connect a tester wich will fire your FBH up independ. This is what i did £50 wasted they then told me because it takes readings from the ecu plus other sensors that the reset at the dealers was a must. My local dealer told me it was an update because of all the problems in the past? Vehicle out of warranty but still carried out F.O.C .
Hope you get to the bottom of it Landylad
|
10th Feb 2009 11:27 pm |
|
|