Member Since: 23 Aug 2022
Location: toledo
Posts: 7
faul suspension
Good morning I just changed front shock absorbers, height sensor, front valve block and for three or four days the car was fine, after those days it started bouncing around the front area and saying that the car would return to its normal height when the system cools down.
I changed the compressor because it was bad and it's still the same.
When you look at the fault code, all of these appear that could be
17th Aug 2024 10:05 am
Centurion
Member Since: 23 Aug 2022
Location: toledo
Posts: 7
BD-IIOBD-II
DTCs: 14
----------------------------
P140A [0x140A]
Status: Confirmed
----------------------------
P140A(21) [0x140A21]
Status: Test Failed, Test Failed in Current Driving Cycle, Temporary, Confirmed, Test Failed Since Time of Last Fault Reset
----------------------------
U0132(86) [0xC13286] File (inactive)
Data bus, suspension ride height control module - no communication
Status: Confirmed, Test failed since the time of the last fault reset
----------------------------
U0421(94) [0xC42194]
Invalid data received - suspension ride height control module
Status: Test failed, Test failed in current driving cycle, Temporary, Test failed since the time of last fault reset
----------------------------
C1A73(1C) [0x5A731C] File (inactive)
Status: Confirmed, Test failed since the time of the last fault reset
----------------------------
C1A27(14) [0x5A2714]
Status: Temporary, Confirmed, Test failed since the time of the last fault reset
----------------------------
C1A03(92) [0x5A0392]
Status: Temporary, Confirmed, Test failed since the time of the last fault reset, Test not completed in the current driving cycle
----------------------------
C1A07(62) [0x5A0762] File (inactive)
Status: Confirmed, Test failed since the time of last fault reset, Test not completed in current driving cycle
----------------------------
C1A20(64) [0x5A2064]
Status: Test failed, Test failed in the current driving cycle, Temporary, Confirmed, Test failed since the time of the last fault reset, Fault indicator is activated
----------------------------
C1130(7A) [0x51307A]
Status: Temporary, Confirmed, Test failed since the time of the last fault reset, Test not completed in the current driving cycle
----------------------------
C112F(72) [0x512F72] File (inactive)
Status: Confirmed, Test failed since the time of last fault reset, Test not completed in current driving cycle
----------------------------
C1130(66) [0x513066] File (inactive)
Status: Confirmed, Test failed since the time of last fault reset, Test not completed in current driving cycle
----------------------------
U0132(87) [0xC13287] File (inactive)
Data bus, suspension ride height control module - no communication
Status: Test failed since the time of the last fault reset
----------------------------
U0421(68) [0xC42168] File (inactive)
Invalid data received - suspension ride height control module
Status: Test failed since the time of the last fault reset
17th Aug 2024 10:06 am
gstuart
Member Since: 21 Oct 2016
Location: kent
Posts: 14107
Hi
Did u calibrate the suspension after fitting the new height sensor plse
Checking to see what the measurements were from the centre of the wheel to the bottom of the wheel arch liner in mm
Plus need to ensure the battery is fully charged and in tip top condition
Would be tempted after calibration to clear all the faults and then see what comes back
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
