Member Since: 03 Jan 2021
Location: Gloucester
Posts: 20
Restricted performance / exhaust gas smell in cabin
Hi all,
I’m hoping you might be able to give me a bit of advice please. I’ve literally just purchased a 2012 D4 3.0 SDV6 - it made the 178 mile journey home without any problems then from day 2 of ownership I’ve ran into issues.
I could smell some exhaust gasses in the cabin and I got the restricted performance warning while driving with hardly any power above 2800rpm. A scan with my IID showed the following codes:-
P1247-00 (27) Turbocharger boost pressure low
P0480-13 (2F) Fan 1 control circuit - General electrical failure - circuit open
P0528-00 (2F) Fan Speed sensor circuit no signal
I then found the right hand EGR pipe as you look at the engine wasn’t properly connected to the butterfly valve thing (sorry i don’t know the proper name) at the top of the engine. I removed the EGR pipes from both sides to clean them as they were really coked up and I cleaned the butterfly valve as well which to me feels a bit sticky when closed - I don’t know if this is normal?
After fitting this all back I found the radiator fan had eaten its cable and shredded the connector. I’ve ordered some new connectors to rebuild the cable but temporarily connected it back to the loom with some wagos to test
The fan control circuit error has now gone since reconnecting the wiring but I still have the fan speed sensor error. I’m not sure if I’m looking at the right values but “Fan speed indicated” was showing 0 - if I increase the revs then it starts to show a value then back at idle it will continue to show a value for a short time then it drops to 0 again. Is this the likely cause of the fan error? I’m not sure if there are other things I should check or is it a case of just replacing the whole fan or possible the module? This morning the speed sensor error decided to change to this one:-
P0483-27 (2A) Fan performance - General signal failure - signal rate of change is above the threshold
Click image to enlarge
Along with this I did get a one off error after testing - I don’t know if this relates to the sticky butterfly valve I mentioned?
P045F-77 (27) Exhaust gas recirculation B - Control stuck closed - Mechanical failure - commanded position is not reachable
Lastly, I get an exhaust gas smell in the cable and from the engine bay on the right hand side as you look at the engine. It’s difficult to test on my own but I have seen some exhaust gases come from this area when revving and the engine almost makes a farting noise sometimes as you go over 3000rpm. I can’t really see any cracks etc visually - is there a particular area I should look or is it best to get it smoke tested?
Thanks everyone and sorry for the long post.
Jamie.
30th May 2023 10:18 am
ianm27
Member Since: 02 Jun 2016
Location: Hertfordshire
Posts: 2154
Hi Jamie, can't help with the fan issue but for the exhaust issue I would definitely suggest getting a smoke test done, could be a number of issues.Uncle Ray's spare wheel protector
Limo Tint
Blackvue front & rear dashcam
Cruise control switch pack
Bodsy's remote for FBH
30th May 2023 12:34 pm
Jamietb
Member Since: 03 Jan 2021
Location: Gloucester
Posts: 20
Thanks - sorry for the slow reply just trying to fit this in alongside work etc.
As an update, I’ve just done a smoke test and I can’t identify any leaks anywhere. I’ve actuated the bypass valve to the secondary turbo and still nothing.
There is what appears to me to be quite a lot of oil around the rear crankshaft seal. There’s also oil up near the secondary turbo but it looks like it’s on a bracket rather than coming from the turbo itself? I’m going to get the lower intercooler pipe off tomorrow to check for oil as there was definitely “some” in the top pipe but I have no idea how much is too much and what this really means. Would it point to the turbo seals maybe?
If anyone has any tips on where else I should be looking / checking that would be really great.
Click image to enlarge
Click image to enlarge
7th Jun 2023 6:17 pm
goldypurple
Member Since: 23 Mar 2018
Location: Norfolk uk
Posts: 96
Check the Crossover pipe and the EGR pipe that connect near the crossover, this can cause gases in the cabin. Also produces restricted performance error.
8th Jun 2023 10:46 am
Jamietb
Member Since: 03 Jan 2021
Location: Gloucester
Posts: 20
Sorry for the slow progress with this but just wanted to give an update. It was indeed the crossover pipe and the oil leak is from the oil filter housing so both being replaced.
Thanks all
6th Jul 2023 7:05 am
onetwentie
Member Since: 25 May 2020
Location: West Yorkshire
Posts: 96
Hi Jamie
I also have the restricted performance and similar codes (last time I checked).
This crossover pipe that you and goldypurple mentioned.. where is it? are you able to post a picture? did replacing the pipes get it out of limp mode?
thanks
8th Jan 2024 12:23 pm
ostosix
Member Since: 19 Mar 2017
Location: Lincoln
Posts: 311
leak
bump this thread where is the crossover pipe as I also have smell in cabin and this thread is a great start
2nd Jul 2024 12:12 pm
Tyty
Member Since: 18 Aug 2022
Location: South West
Posts: 77
Its at the back of the engine above the transmission. Pain in the to do with the body on but it is possible... however most garages will split the body to reach and make life easier.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum