Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Technical (D3)

D3 2005 HSE with SRS air bag warning lamp
Post Reply  Down to end
Page 1 of 1
ManxMike
 


Member Since: 28 Nov 2023
Location: Santon
Posts: 8

Isle Of Man 2005 Discovery 3 TDV6 HSE Auto Siberian SilverDiscovery 3
D3 2005 HSE with SRS air bag warning lamp

Hi folks I have just fixed a water leak in the passenger footwell of my D3, which involved removing the CJB to get access to the hose outlet. This all seemed to go fairly well except that I now have an airbag warning light. I have a simple scanner that shows faults B0010 and B0011 passenger front stage 1 & 2. These can be reset but come back within 2 seconds. When I look at data streams I note that DCR 2 & 3 are 10ohms where as all other resistors are 2 ohms. Can anyone share the SRS electrical diagram or help advise which connections I should check. Hopefully the SRS does not go through rear connectors on CJB? Many thanks Mike
 Currently D3 2.7 TDV6 owner and restorer
Previously a D2 owner and series 2a before this 
 
Post #235863111th Jan 2024 10:34 pm
View user's profile Send private message View poster's gallery Reply with quote
Pete K
 


Member Since: 15 Jan 2016
Location: GL
Posts: 10475

England 2005 Discovery 3 TDV6 HSE Auto Rimini RedDiscovery 3

I’d pull the glovebox down
Peer up and see if you can see the rear of the pass airbag.
Maybe disconnect battery
Unplug airbag. Reseat connector.
Retry clearing code

I don’t think it goes through cjb
  
Post #235863511th Jan 2024 10:55 pm
View user's profile Send private message View poster's gallery Reply with quote
ManxMike
 


Member Since: 28 Nov 2023
Location: Santon
Posts: 8

Isle Of Man 2005 Discovery 3 TDV6 HSE Auto Siberian SilverDiscovery 3

Thanks Pete will try this 😎
 Currently D3 2.7 TDV6 owner and restorer
Previously a D2 owner and series 2a before this 
 
Post #235863711th Jan 2024 11:07 pm
View user's profile Send private message View poster's gallery Reply with quote
ManxMike
 


Member Since: 28 Nov 2023
Location: Santon
Posts: 8

Isle Of Man 2005 Discovery 3 TDV6 HSE Auto Siberian SilverDiscovery 3

Hi Pete I lowered the glove box as suggested but everything was in place. Also I could not see where the dashboard air bag connects. However I also removed the small cover behind the bonnet release lever to have a look at everything I had dismantled and found one of the three small connectors that I had disturbed when installing the CJB was not fully pushed home. Reseating this immediately fixed the air bag light. Thanks for the encouragement as you advice got me to look again. The CJB was a swine of a job but I can now look back on it with relief that the problem is fixed. Best wishes Mike
 Currently D3 2.7 TDV6 owner and restorer
Previously a D2 owner and series 2a before this 
 
Post #235908315th Jan 2024 10:25 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site