Member Since: 03 Oct 2018
Location: Kent
Posts: 615
Door actuators a comparison of cheap and expensive
Can anyone confirm if the door actuators are backwards compatable ??
I mean can you fit a newer keyless type in place of the older non keyless type ?
Thanks
12th Mar 2023 11:18 am
Lrstaylor
Member Since: 03 Oct 2018
Location: Kent
Posts: 615
Just to follow up on this, yes you can. Iv started another thread regarding door actuators
15th Mar 2023 4:48 pm
Lrstaylor
Member Since: 03 Oct 2018
Location: Kent
Posts: 615
Door actuators a comparison of cheap and expensive
Iv bought x2 door actuators off the bay 1 for less than £7 unbranded the other £28 sellers own brand x5 year warrenty so far I can see no obvious difference
This post has been merged by the site administration team
15th Mar 2023 4:51 pm
Lrstaylor
Member Since: 03 Oct 2018
Location: Kent
Posts: 615
Well I'm happy to report both locks work as they should iv fitted both with no issues and now have a spare to keep in the garage
I partially stripped them both down and its fair to say they were most likley made in the same chinease factory . The original lock had made in Germany label on it over another label I think at some point it had been swopped out and someone put a label for a sport over a label from a D3 or even a freelander.
Have now got it down to 35 mins to swop out the lock the key being to use a trim tool to hold open the furthest most glass latch lift up the glass at that end bit of strong tape then clip it out at the front end.
Let's see how long it lasts.
18th Mar 2023 6:26 pm
kajtzu
Member Since: 10 Aug 2017
Location: Helsinki
Posts: 6741
FWIW, I got two door latch actuator modules in summer 2021. They were original LR, had made in Germany stickers on them and were manufactured in January 2021.
18th Mar 2023 6:58 pm
riverblanche
Member Since: 31 Aug 2010
Location: retford'ish
Posts: 2225
Hi,
what have you found as the best way to unclip the cable from the outside handle to the actuator
do you remove the outside handle complete with cable still attached
(I have never managed to even get the outside cover off the handle to start with )
or do you manage to disconnect the cable before removing the actuator,
thats what I have done in the past 1/4 turn the end of the cable via the catch keeper opening.
even though I have done 1 on RRS, 2 on FL2 and 3 on D3's (2 on current D3) I still find that the hardest part
Member Since: 03 Oct 2018
Location: Kent
Posts: 615
I unbolt the actuator and let it drop then hold it with my left hand and just use a small probe/screw driver threw the large gap in the door where the actuator was and prise it out from its little clip then just rotate the wire and it pops out.....does that make sense ? Iv never yet removed the outer door handle.
18th Mar 2023 7:36 pm
riverblanche
Member Since: 31 Aug 2010
Location: retford'ish
Posts: 2225
Hi,
yes that sounds the same way I have done them, tried to explain the same way
I even have a special tool now to release the "tooth" of the plastic clip holding the cable outer
(its a long ali nail with the tip bent 90 degrees )
easily pops off then
its putting that cable end back on that I find so fiddly long nose pliers seem to work ok last time,
although I hope I dont have to do any more of them
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum