Member Since: 28 Aug 2021
Location: Swindon
Posts: 56
Fast flashing indicators when reverse selected
Hi All
Had D4 rear lights fitted for a while with no problems, last week end I fitted the pre facelift D4 headlamps and I get a flickering when I first put them on and I know there is a fix for that but cant find it in the past posts. I think you have to change the headlight type selection with the OBD tool??
Not the end of the world but annoying and also since the headlight swap when I select reverse the indicators start going mad is that because I have to add a resistor some where or is it a short maybe??
Appreciate your opinions and or help
3rd Dec 2022 6:57 pm
MikeO
Member Since: 15 Jan 2014
Location: The Cotswolds
Posts: 1384
For the headlights, I think you need to edit the CCF which requires an IID tool or equivalent, not just an OBD tool.
Re the indicators, do you mean they get activated by selecting reverse? Or do you mean they are already on but selecting reverse makes them go mad?2016 Skoda Octavia VRS Estate
<gone>2009 FF Vogue TDV8 Buckingham Blue</gone>
<gone>2015 BMW 520D SE (not my favourite car)</gone>
<gone>2009 D3 HSE Galway Green</gone
3rd Dec 2022 7:04 pm
wanborough one
Member Since: 28 Aug 2021
Location: Swindon
Posts: 56
Hi
Thanks for that info
Really strange put hazards on and put it in reverse and all is normal, put each side indicators on and reverse and they start going fast on both but noticed when I took it out of reverse the right hand indicator started occasionally to have a hic cup (you can hear the relay) in between flashes then it came good after 15 or 20 seconds. At one point I went round the back and the right one was not working then did it again and all was working ok
All this started after I put the front D4 headlights on her or is that just a coincidence maybe!
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum