Member Since: 31 Dec 2021
Location: North Wales
Posts: 75
Grinding noise.
Right then.
Wife's D4, 2011 3.0tdv6.
Griding and vibration, wife's been complaining for a short time, but knowing the front disks need replacing (wharped) I haven't really given it a thought.
Drove it last weekend and the grinding sounds like metal on metal brake pads, so pulled over and tried to have a look. Could see any think so decided to turn round and head home, did the 3 point turn thing, and started to drive away, big bang that shook the truck, like a brake pad making a bid for freedom. And the grinding posisted. Anyway, this weekend I've had the wheels off to check the brakes, it is not the brakes, albeit I have ordered disks, carrier's, pads and wear sensors for all four corners. It's not the EPB or the front wheel bearings, these were changed only a few thousand miles ago. And there is no movement in them, jacked up or on the ground.
Does anyone have any idea what this could possibly be.2006 D3 aka Lipstick (bad purchase) my daily.
2012 D4 aka Fiji (wife named it) only drive to the garage/mot station.
2003 L200 aka Miss Piggy, faded blotchy red pink, currently sat in naughty corner in disgrace due to a knocking bottom end (It was the cheapest 4x4 when i bought it)
14th May 2022 2:00 pm
DN D3 Decade
Member Since: 23 Jun 2006
Location: W.London.
Posts: 2346
CV joint shot perhaps ?D3 owned from new, P017 brake recall, BAS FBHIC, new FBH, LR013487 oil pump, new water pump. RRS front lower suspension arms. New suspension compressor/ relay. New Denso alternator. CuNifer rear brake pipes. New GKN rear propshaft. New HPFP belt & tensioner. New A/C Condenser.NO WARRANTY for many many years.
14th May 2022 2:06 pm
trainmanone
Member Since: 19 Dec 2014
Location: stockport
Posts: 366
I had similar thing with my D3 not so long ago after three point turn ,sounded like a hammer banging on brake disc turned out to be front prop bearing collapsed .
14th May 2022 5:07 pm
Mambo
Member Since: 31 Dec 2021
Location: North Wales
Posts: 75
Hi DN and Trainmanone,
Thank you for your replies, I was kindda thinking down this line of thought, Trainmanone that is the best description of the sound, hence i suspected slipped pads, after experiencing this in the past on older disked vehicles.
Time to price these too, and watch a couple of YouTube tutorials.2006 D3 aka Lipstick (bad purchase) my daily.
2012 D4 aka Fiji (wife named it) only drive to the garage/mot station.
2003 L200 aka Miss Piggy, faded blotchy red pink, currently sat in naughty corner in disgrace due to a knocking bottom end (It was the cheapest 4x4 when i bought it)
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
