Member Since: 14 Sep 2011
Location: annecy
Posts: 233
2011 Discovery 4 EGR replacement 3.0 V6
Anyone done this on this engine? I have seen loads of cute Youtube videos but all for the D3 and none very helpful.
Any pointers? I have the Workshop manual but it is opaque to say the least..
30th Apr 2022 3:06 pm
sceh
Member Since: 14 Sep 2011
Location: annecy
Posts: 233
No-one done this when it is one of the most common problems? Odd
8th May 2022 9:39 am
OvalAutos
Member Since: 28 Dec 2018
Location: Cradley Heath
Posts: 382
Yes, it's doable. But be very careful when undoing the 2x M6 bolts that hold the pipe to the exhaust manifold. These get very tight and are prone to snapping. If they snap, then the only option is to lift the body off to allow access to drill them out.
If you're just changing the valve, then I would suggest that undo the 2x screws (4mm hex) that clamp the pipe to the valve. Tricky, but the cursing is loads less than that feeling when the bolt snaps.Joe
9th May 2022 7:20 am
Lazydave
Member Since: 07 Jul 2019
Location: Birmingham
Posts: 87
2010 HSE
Full service genuine parts.
Front and rear pads.
Turbo oil drain pipe mod.
LED interior lights upgrade.
Both rear door actuators.
Tailgate handle/ switch.
Facelift grille and rear lights.
Fitted cross bars.
New rear discs and pads.
New RH inlet manifold.
New air con condensor.
New battery.
New EGR pipe.
New front discs and pads.
New propshaft.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
