jekyllman
Member Since: 27 Dec 2020
Location: Pocatello
Posts: 42
![](templates/vbnew/images/spacer.gif)
![2005 LR3 4.4 V8 HSE Auto Bonatti Grey 2005 LR3 4.4 V8 HSE Auto Bonatti Grey](../images/veh/bonatti_grey.gif)
|
Worried about a serious transmission issue - help! |
|
Quick story: Did a trail in Utah (USA) with some steep inclines (around 30-40 deg at times) with no issues. Temps around 80 deg F outside. Starting coming back down the mountain on the sand dunes and hit one weird and almost rolled it. Got stuck with it tilted to around 35-40 deg on its side. Freaked me out a bit. However, I hooked it up to my friend’s LR4 to keep me from rolling, dug out the wheels and put it in reverse. It started backing out then it threw a transmission fault, limited gears. My power was completely cut. I couldn’t get any power out of it and revs stayed really low. I cycled the ignition and as soon as revs got above about 2000rpm it threw the fault again. Transmission fluid temp never got above 106 deg C that I noticed on the GAP tool. Finally ended up getting pulled backwards to get unstuck. I turned around to gun it out the way I came but it kept throwing the fault and cut my power. It took 5-6 tries before it finally let me access the power I needed to get up the hill and out. It would shift me into 2nd then 3rd gear. Went into manual mode and in both high and low range. I cleared codes with the GAP tool. Nothing was working. I don’t understand what I could get any power. Once I got out we continued down the mountain and all the way home with zero issues. Codes I got with the transmission were the following:
P0730-00 (6D) - Incorrect gear ratio
P0736-00 (ED) - Reverse incorrect ratio
Should I be stressed about a bad transmission??
|
25th Mar 2022 8:40 am |
|
|
altblech-schrauber.de
Member Since: 15 Feb 2021
Location: Lingen
Posts: 26
![](templates/vbnew/images/spacer.gif)
![2007 Discovery 3 TDV6 SE Auto Tonga Green 2007 Discovery 3 TDV6 SE Auto Tonga Green](../images/veh/tonga_green.gif)
|
howdy,
since you got both "slip" faults:
P0730-00 (6D) - Incorrect gear ratio
P0736-00 (ED) - Reverse incorrect ratio
you might be in luck.
those ratio codes mean that some or one of the clutches are slipping, since you have been o
n a steep angle, and forward and reverse was monitored i would asume that you filter caught some air.
I would check the tranny oil level first, at this point it would be also good to change it, just to be safe, slipping a auto clutch burns up the oil pretty bad.
If the fault persist, u recomend you stop using the car and diagnose it thoroughly, burning up clutch drum (or bell or hatever its called) is a pain in the , and i a asume its not that easy to get genuine ZF parts over there.
the best of luck from across the duck pond
|
25th Mar 2022 8:50 am |
|
|
jekyllman
Member Since: 27 Dec 2020
Location: Pocatello
Posts: 42
![](templates/vbnew/images/spacer.gif)
![2005 LR3 4.4 V8 HSE Auto Bonatti Grey 2005 LR3 4.4 V8 HSE Auto Bonatti Grey](../images/veh/bonatti_grey.gif)
|
Thanks for the response. I ended up driving it home 450 miles with no issues at all. Hope that is a good sign. I had just cleaned out the transmission solenoids, replaced the rubber parts above the valve body, and add new fluid before going on this trip so it made me nervous
|
26th Mar 2022 10:43 pm |
|
|