Phunter
Member Since: 04 Nov 2013
Location: USA
Posts: 10
  
|
| Tyre pressure monitor system fault |
|
Hello
I recently took the right front wheel well cover out to replace the upper control arm. I remember pushing the tire pressure antenna up towards the lights on the front of the car while working on the arm replacement.
After getting the job done and with the first drive the tyre pressure light came on and then the tyre pressure monitoring fault message.
Is there a certain place the antenna must reside behind the wheel well? I am sure left it up by the lights.
If I take the wheel back off and move the antenna to where you guys tell me it should be will the fault message go away with driving? I don’t have a gap tool and don’t want to pay a dealer to get the message to go away? I hope there is an easy fix. I don’t know if unplugging battery works with this fault messages.
Thanks for any advice you are willing to give me
|
 20th Mar 2022 5:37 pm |
|
|
aja4x4
Member Since: 14 Apr 2019
Location: Westbury
Posts: 2462
 
|
I havent done a LR3 but the LR4 ones are attached to the back of the wheel arch linner Andrew
D3 2.7tdv6 2005
D4 3.0 SDV6 Commercial died and gone to LR heaven
D5 3.0 SDV6 HSE
|
| 20th Mar 2022 7:53 pm |
|
|
Phunter
Member Since: 04 Nov 2013
Location: USA
Posts: 10
|
I assume it just flat up against the plastic wheel arch. I do. It remember a way it was fastened or a cut out area for it.
I can remove it and place it back up against the plastic wheel arch. Wondering if this will take the fault away or if it requires a computer or code clearing device to do this
Thanks for any and all thoughts
Sincerely
|
| 20th Mar 2022 10:08 pm |
|
|
