Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Webasto Fuel Burning Heater

First time cold enough for FBH and not working?
Post Reply  Down to end
Page 1 of 1
Garwood56
 


Member Since: 24 Jun 2021
Location: West Sussex
Posts: 446

United Kingdom 2005 Discovery 3 TDV6 SE Auto Cairns BlueDiscovery 3
First time cold enough for FBH and not working?

Morning all, so this morning was only 3 degrees and in my ownership this is the first time the FBH should come on. Unfortunate no noise or FBH exhaust smoke, was looking forward to that bit !! Are there basic checks I can perform, I have made sure I have a full tank of fuel. Thanks
  
Post #22598992nd Nov 2021 7:22 am
View user's profile Send private message View poster's gallery Reply with quote
Pete K
 


Member Since: 15 Jan 2016
Location: GL
Posts: 10719

England 2005 Discovery 3 TDV6 HSE Auto Rimini RedDiscovery 3

If you have a GAP IID, there is a test procedure you can run which can kick it back into life.

If you don't, then removing the FBH fuse (under the bonnet) for 30 seconds is the done thing I understand to reset.

There is a massive section on the FBH in the Wiki (link at the top?)
  
Post #22599342nd Nov 2021 12:30 pm
View user's profile Send private message View poster's gallery Reply with quote
ianm27
 


Member Since: 02 Jun 2016
Location: Hertfordshire
Posts: 2154

England 2012 Discovery 4 3.0 SDV6 GS Auto Orkney GreyDiscovery 4

From the Wiki page - link at the very top of the forum page:

https://www.disco4.com/wiki/Fuel_Burning_Heater
 Uncle Ray's spare wheel protector
Limo Tint
Blackvue front & rear dashcam
Cruise control switch pack
Bodsy's remote for FBH 
 
Post #22599742nd Nov 2021 4:26 pm
View user's profile Send private message View poster's gallery Reply with quote
lynalldiscovery
 


Member Since: 22 Dec 2009
Location: Maidstone
Posts: 7274

United Kingdom 2006 Discovery 3 TDV6 Metropolis LE Auto Bonatti GreyDiscovery 3

Just clear the codes, then see how it goes.
  
Post #22600393rd Nov 2021 7:36 am
View user's profile Send private message View poster's gallery Reply with quote
Gazellio
 


Member Since: 08 Jan 2011
Location: Chilterns
Posts: 4130

United Kingdom 2009 Discovery 4 TDV6 SE Auto Indus SilverDiscovery 4

Pete K wrote:
If you have a GAP IID, there is a test procedure you can run which can kick it back into life.

If you don't, then removing the FBH fuse (under the bonnet) for 30 seconds is the done thing I understand to reset.

There is a massive section on the FBH in the Wiki (link at the top?)


Where exactly under the bonnet is this fuse and what number if in a box?
  
Post #22604285th Nov 2021 8:23 am
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
Garwood56
 


Member Since: 24 Jun 2021
Location: West Sussex
Posts: 446

United Kingdom 2005 Discovery 3 TDV6 SE Auto Cairns BlueDiscovery 3

Thanks for the replies. Did a reset by removing fuse for 10mins. Fired up perfectly this morning in 0 degrees. 👍
  
Post #22604465th Nov 2021 9:33 am
View user's profile Send private message View poster's gallery Reply with quote
Gazellio
 


Member Since: 08 Jan 2011
Location: Chilterns
Posts: 4130

United Kingdom 2009 Discovery 4 TDV6 SE Auto Indus SilverDiscovery 4

Did you have the ignition on or off when fuse removed for 10 minutes? (I assume there is power to that fuse without ignition to allow remote starts)
  
Post #22604595th Nov 2021 10:19 am
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
Garwood56
 


Member Since: 24 Jun 2021
Location: West Sussex
Posts: 446

United Kingdom 2005 Discovery 3 TDV6 SE Auto Cairns BlueDiscovery 3

No ignition off but I forgot to say I also disconnected both wiring blocks at the same time so no power at all.
  
Post #22604615th Nov 2021 10:24 am
View user's profile Send private message View poster's gallery Reply with quote
Lee Trinder
 


Member Since: 12 Aug 2018
Location: Henley in arden
Posts: 516

2007 Discovery 3 TDV6 HSE Auto Stornoway GreyDiscovery 3

Great news it’s going again. I fitted a remote to start mine on the colder mornings but still preheat it in the summer occasionally just to make sure it still works.
  
Post #22605195th Nov 2021 4:54 pm
View user's profile Send private message View poster's gallery Reply with quote
Gazellio
 


Member Since: 08 Jan 2011
Location: Chilterns
Posts: 4130

United Kingdom 2009 Discovery 4 TDV6 SE Auto Indus SilverDiscovery 4

so yours will fire up in summer temperatures?
  
Post #22605285th Nov 2021 6:08 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
Lee Trinder
 


Member Since: 12 Aug 2018
Location: Henley in arden
Posts: 516

2007 Discovery 3 TDV6 HSE Auto Stornoway GreyDiscovery 3

Yeah, I can turn it on whenever, it works off the third button on the key and runs for thirty minutes or until it reaches a set temp. The car is a 2007 model
I only use it occasionally during the summer to make sure it still works when it comes to winter. I do the same with my central heating.
  
Post #22605325th Nov 2021 6:19 pm
View user's profile Send private message View poster's gallery Reply with quote
Pete K
 


Member Since: 15 Jan 2016
Location: GL
Posts: 10719

England 2005 Discovery 3 TDV6 HSE Auto Rimini RedDiscovery 3

Gazellio wrote:
Pete K wrote:
If you have a GAP IID, there is a test procedure you can run which can kick it back into life.

If you don't, then removing the FBH fuse (under the bonnet) for 30 seconds is the done thing I understand to reset.

There is a massive section on the FBH in the Wiki (link at the top?)


Where exactly under the bonnet is this fuse and what number if in a box?


Picture here. Fuse 28

https://www.disco3.co.uk/wiki/Fuel_Burning_Heater
  
Post #22605335th Nov 2021 6:24 pm
View user's profile Send private message View poster's gallery Reply with quote
Garwood56
 


Member Since: 24 Jun 2021
Location: West Sussex
Posts: 446

United Kingdom 2005 Discovery 3 TDV6 SE Auto Cairns BlueDiscovery 3

On another note now that it’s working 😎 there seems to be a plethora of different ideas and products for FBH remote starting. However does anyone know of a simple timer set up that can be wired in with a small display wired through to the dash. Thanks.
  
Post #22605796th Nov 2021 1:12 am
View user's profile Send private message View poster's gallery Reply with quote
Motolab
 


Member Since: 18 Oct 2019
Location: Sleen
Posts: 1820

Netherlands 2006 Discovery 3 TDV6 HSE Auto Zambezi SilverDiscovery 3

Yeah.. dat is covered here before many times… have a search

It is even in the wiki here…

https://www.disco3.co.uk/wiki/Fuel_Burning_Heater

with display and timer? Simply take a webasto 1533 clock..
They are plenty on ebay etc.
 Best regards
Harold

Always looking for Pre '55's & Pre war British Motorcycles! knowing or having one for sale? PM please. I visit the UK 6 times a year

Ps. I edit my texts quite often, english is not my native language, so I will edit My “typo’s” etc. Wink 
 
Post #22605826th Nov 2021 1:43 am
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site