Calle
Member Since: 17 Mar 2008
Location: Copenhagen
Posts: 68
  
|
Every year my old burner has a lock down because of too many failstarts. I have it reset by my mechanic, but after a while it´s the same problem again. Should I repair it or buy a new ? BTW is it possible to reset the burner with an app., and if - which ?
Best regards Calle Calle - disguised as adult.
Discovery 3 TDV6 HSE
Ducati 750 SS
Cervelo P2
|
 30th Dec 2020 4:54 pm |
|
|
Kviasen
Member Since: 24 Dec 2020
Location: Norway
Posts: 107
|
I think you can just remove fuse to it in the engine compartment fuse box for half an hour or so then it will restart and go in ready for start mode.
Webasto software can also reset it of course.
But if this happens all the time i would maybe get it serviced.
|
| 30th Dec 2020 5:27 pm |
|
|
Prette
Member Since: 16 Mar 2020
Location: Previously Stoke-ST4 (pre-pandemic), Mostly The Hague (NL) partially Lyngby (DK) certainly somewhere
Posts: 160
|
Hi Calle,
without the diagnostic tool it is difficult to know what exaclty is happening with the FBH. Is it locking out completelly? or simply not starting?
I can possibly use the my diag tool (and perhaps clean the fault) for you. Also, is the FBH is partially running, it will be possible to see what is going on when it starts.
Drop me a PM and we can try to meet. If you are willing to drive here, I am in Lyngby/Sorgefri area until 9 Jan.
Or I can get to you (to get the car cold) if it is easy.
|
| 30th Dec 2020 5:31 pm |
|
|
Prette
Member Since: 16 Mar 2020
Location: Previously Stoke-ST4 (pre-pandemic), Mostly The Hague (NL) partially Lyngby (DK) certainly somewhere
Posts: 160
|
Kviasen wrote:I think you can just remove fuse to it in the engine compartment fuse box for half an hour or so then it will restart and go in ready for start mode.
Webasto software can also reset it of course.
But if this happens all the time i would maybe get it serviced.
I agree with Kviasen, a service is probably a goosd idea. I will do mine in the summer 
Also good idea to try the Reset of the FBH by pulling the fuse. https://disco3.co.uk/wiki/Fuel_Burning_Heater#Resetting
|
| 30th Dec 2020 5:34 pm |
|
|
