Codyusa
Member Since: 13 May 2012
Location: Pa
Posts: 16
![](templates/vbnew/images/spacer.gif)
![2006 Discovery 3 4.4 V8 SE Auto Buckingham Blue 2006 Discovery 3 4.4 V8 SE Auto Buckingham Blue](../images/veh/buckingham_blue.gif)
|
Shark fin removal...I must be an idiot |
|
For the life of me I can't figure out how to remove my shark fin so I can repair and reinstall. I have the head liner down in the back and am at a loss. Anyone have a detail illustration on how this is done. I cant find it any where. I need removing fin for dummies like pictures.
Thanks
|
21st May 2012 1:18 am |
|
|
B16 KJR
Member Since: 10 Jul 2006
Location: Rosyth, Fife
Posts: 3005
![](templates/vbnew/images/spacer.gif)
|
You take off the plastic "cowling" then gently pull down the headlining. If you shine a torch in, you will see 2 nuts under the fin. It is a VERY tight fit and some people advise taking off the rear pillar trims, but I managed to get my hand in with a spanner, 10mm I think, and undo the nuts. Be very careful with the headlining and dont crease it, if you feel its too small a gap to get your hand in, take the rear pillars off and that lets the lining drop down a bit more.
|
21st May 2012 12:41 pm |
|
|
bkehoe
Member Since: 25 Feb 2006
Location: Wexford
Posts: 1481
![](templates/vbnew/images/spacer.gif)
![2005 Discovery 3 TDV6 HSE Auto Zambezi Silver 2005 Discovery 3 TDV6 HSE Auto Zambezi Silver](../images/veh/zambezi_silver.gif)
|
There's no nuts above the headlining holding my fin on. I have the glass roof version; perhaps it's different with the standard one.
With the glass roof version you simply remove the 2 security torx screws on the outside and then the main body of the pod will slide forward. Its entry 'grommet' is simply stuck onto the body and (after disconnecting the cable internally) you can just rip it off.
The mounting frame for the pod body is then just stuck to the glass roof and can be removed by ripping it off as above. IE - 05 D3 TDV6 HSE - Zambezi Silver
SA - 07 VW Golf TDI - White - Sold!
|
21st May 2012 7:09 pm |
|
|
Codyusa
Member Since: 13 May 2012
Location: Pa
Posts: 16
![](templates/vbnew/images/spacer.gif)
![2006 Discovery 3 4.4 V8 SE Auto Buckingham Blue 2006 Discovery 3 4.4 V8 SE Auto Buckingham Blue](../images/veh/buckingham_blue.gif)
|
bkehoe wrote: There's no nuts above the headlining holding my fin on. I have the glass roof version; perhaps it's different with the standard one.
With the glass roof version you simply remove the 2 security torx screws on the outside and then the main body of the pod will slide forward. Its entry 'grommet' is simply stuck onto the body and (after disconnecting the cable internally) you can just rip it off.
The mounting frame for the pod body is then just stuck to the glass roof and can be removed by ripping it off as above. ![Wink Wink](images/smiles/icon_wink.gif)
I have the glass roof as well. I keep looking for the bolts under and can't find them. I do see the special hex screws on top and the front piece of the antenna does seem glued to the glass. I also see a small puck like disk which is where the wires come down through the body at the very back of the roof where the metal is. I do not see any nutts or bolts holding that down. Could that be the navigation? Need to remove that as well so I can re-run the wires.
Thanks
|
21st May 2012 7:18 pm |
|
|
bkehoe
Member Since: 25 Feb 2006
Location: Wexford
Posts: 1481
![](templates/vbnew/images/spacer.gif)
![2005 Discovery 3 TDV6 HSE Auto Zambezi Silver 2005 Discovery 3 TDV6 HSE Auto Zambezi Silver](../images/veh/zambezi_silver.gif)
|
The disk you mention is what I called the grommet. It is simply stuck on with very sticky tape. I was quite able to rip mine off though. As I mentioned the front piece will slide forward and out, it's just its base framework that's stuck onto the glass with the same extra sticky tape thats used on the grommet.
In Europe the pod on the D3 was only used for the phone antenna. However in the US I believe it may have been used for Sirius so if you have that then think carefully before damaging anything. The GPS antenna is beneath the rear upper brake light. IE - 05 D3 TDV6 HSE - Zambezi Silver
SA - 07 VW Golf TDI - White - Sold!
|
21st May 2012 7:34 pm |
|
|
B16 KJR
Member Since: 10 Jul 2006
Location: Rosyth, Fife
Posts: 3005
![](templates/vbnew/images/spacer.gif)
|
Quote:I have the glass roof as well.
You never mentioned that !!
|
21st May 2012 7:37 pm |
|
|
bbyer
Member Since: 25 Dec 2008
Location: Edmonton Alberta
Posts: 702
![](templates/vbnew/images/spacer.gif)
![2005 LR3 4.4 V8 HSE Auto Zambezi Silver 2005 LR3 4.4 V8 HSE Auto Zambezi Silver](../images/veh/zambezi_silver.gif)
|
Glass roof - no interior bolts. |
|
There are two sharks fin attachment arrangements. The all metal roof version uses the nut and bolt setup referred to; the glass roof version is effectively glue on.
For the glass roof version, a plastic "gasket" glues on to the glass and metal just where the glass roof stops at the rear and the metal section commences. The two short torx screws thread into the plastic gasket. The antenna cable drops thru a hole in the metal roof portion just rear of where the glass sheet stops.
A LR pdf view of both is in my gallery per below.
http://www.disco3.co.uk/gallery/thumbnails.php?album=3762 2005 LR3 HSE 4.4L AJ-V8 petrol; Traxide Dual Battery; PIAA 2500K Yellow Ion H11 Fog Light bulbs; CounterAct LT-2 Capacitive Corrosion control; LLumar AIR80 Blue clear Infra Red blocking side window film; Liftgate manual release; Schrader Valve "air in" mod to OEM air suspension reservoir tank; Akebono ceramic pads; OEM solid vented discs; LR4 design hitch receiver; Wiggs D4 MOST bluetooth module; Clock on the Dash; 3 Flash signal light mod; Backup Camera; 2015/16 Nav Data update.
|
21st May 2012 7:40 pm |
|
|
Codyusa
Member Since: 13 May 2012
Location: Pa
Posts: 16
![](templates/vbnew/images/spacer.gif)
![2006 Discovery 3 4.4 V8 SE Auto Buckingham Blue 2006 Discovery 3 4.4 V8 SE Auto Buckingham Blue](../images/veh/buckingham_blue.gif)
|
B16 KJR wrote:Quote:I have the glass roof as well.
You never mentioned that !! ![Whistle Whistle](images/smiles/icon_whistle.gif)
Sorry about that, shows what I know I thought they all had that roof.
Thanks for the help.
|
21st May 2012 7:45 pm |
|
|
Codyusa
Member Since: 13 May 2012
Location: Pa
Posts: 16
![](templates/vbnew/images/spacer.gif)
![2006 Discovery 3 4.4 V8 SE Auto Buckingham Blue 2006 Discovery 3 4.4 V8 SE Auto Buckingham Blue](../images/veh/buckingham_blue.gif)
|
Thanks everyone for all the help. I really appreciate it and my problem is now solved.
Thanks again!
|
21st May 2012 7:46 pm |
|
|
B16 KJR
Member Since: 10 Jul 2006
Location: Rosyth, Fife
Posts: 3005
![](templates/vbnew/images/spacer.gif)
|
Glad your all sorted
|
22nd May 2012 12:33 pm |
|
|
slick91
Member Since: 13 Oct 2014
Location: Newcastle upon Tyne
Posts: 32
![](templates/vbnew/images/spacer.gif)
![2010 Discovery 4 3.0 TDV6 HSE Lux Auto Zermatt Silver 2010 Discovery 4 3.0 TDV6 HSE Lux Auto Zermatt Silver](../images/veh/zermatt_silver.gif)
|
mines started to leak at the grommet (glass version, disco4) will some silicone be suffice to reseal it seeing as it will be hidden from view by the plastic cover? cheers
|
13th Jan 2016 3:57 pm |
|
|
lynalldiscovery
Member Since: 22 Dec 2009
Location: Maidstone
Posts: 7274
![](templates/vbnew/images/spacer.gif)
![2006 Discovery 3 TDV6 Metropolis LE Auto Bonatti Grey 2006 Discovery 3 TDV6 Metropolis LE Auto Bonatti Grey](../images/veh/bonatti_grey.gif)
|
Problem with silicone is it never really lasts.
You can get pu sealant from toolstation etc and thats pretty good.
Ive used this on the 90 and the boat, all still leak free.
http://www.toolstation.com/shop/p67949
|
13th Jan 2016 5:36 pm |
|
|
slick91
Member Since: 13 Oct 2014
Location: Newcastle upon Tyne
Posts: 32
![](templates/vbnew/images/spacer.gif)
![2010 Discovery 4 3.0 TDV6 HSE Lux Auto Zermatt Silver 2010 Discovery 4 3.0 TDV6 HSE Lux Auto Zermatt Silver](../images/veh/zermatt_silver.gif)
|
thanks ill get some and replace the silicone I've just put on
i know i should of waited lol…..
cheers for the link too mate
|
13th Jan 2016 7:41 pm |
|
|
Errant
Member Since: 29 Oct 2020
Location: CA
Posts: 28
![](templates/vbnew/images/spacer.gif)
![2011 LR4 5.0 V8 HSE Auto Fuji White 2011 LR4 5.0 V8 HSE Auto Fuji White](../images/veh/fuji_white.gif)
|
Is the rubber grommet one piece or two? I need to fair or replace wiring through it, as well. The white wire is broken.
|
15th Dec 2020 11:22 pm |
|
|