Member Since: 10 May 2020
Location: Norway
Posts: 77
Door cladding seal fit
One rear door cladding seal part no CGE500420 was missing on my Discovery 3. I bought a new one, but it does not come with the mounts to fasten the screws. The seal has four screws and I am missing the four plastic mounts which sit behind the seal to attach the screws. Any ideas where these may be obtained? Or an alternative method of fastening? Gluing is not good option.
16th May 2020 9:31 am
kajtzu
Member Since: 11 Aug 2017
Location: Helsinki
Posts: 6575
Member Since: 10 May 2020
Location: Norway
Posts: 77
Thanks for the tip. Can't find any fixings on that drawing that looks like the ones I would need. It looks like they may be integral to the wheel arch trim on the door frame. But there is no trace of them on the right side door trim on my car, strangely enough. I could probably cut four soft rubber blocks and glue them on, and fasten the screws in the blocks.
16th May 2020 7:20 pm
Lee Trinder
Member Since: 12 Aug 2018
Location: Henley in arden
Posts: 515
Do you have a picture of the seal on the other door?
If it’s the bit I’m thinking of I’m sure it screws into the arch moulding on the door
16th May 2020 7:23 pm
Lrsg
Member Since: 10 May 2020
Location: Norway
Posts: 77
This is the upper one
And the lower one
16th May 2020 8:03 pm
Lrsg
Member Since: 10 May 2020
Location: Norway
Posts: 77
These fixings are missing on the right door, and this is where the rubber seal is attached by screws.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum