wopac5
Member Since: 20 May 2007
Location: Karratha
Posts: 146
  
|
| EAS compressor replacement. |
|
I have need to do a swap out of the compressor. The dealer will execute the work, (my son is apprenticed to the dealer and will be doing the physical work), however, the dealer has only been appointed LR dealer this year...my previous dealer has moved on...
As such, they will have little experience in some aspects of LR stuff, and the EAS is something not done reguarly.
Has anyone done this? or have access to the procedure for doing this? The dealer should have the books by now, but info from my son would indicate that some stuff is still to be sent, and I don't want him exposed to some hazards 9hi air pressures etc) when he does the work.
Tony
|
 25th Jan 2008 2:27 am |
|
|
catweasel
Member Since: 05 May 2006
Location: Bundaleer
Posts: 4805
|
if they have the internet they can look up the info anytime 
|
| 25th Jan 2008 1:39 pm |
|
|
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14372
  
|
Instructions say
Using T4 (computer) depressurize the system.
Raise and support the vehicle.
Remove the air suspension compressor lower cover.
Remove the 3 bolts.
Release the 5 clips.
CAUTION: Always plug any open connections to prevent contamination.
Remove the air suspension compressor.
Disconnect the 3 air lines.
Disconnect the 2 electrical connectors.
Remove the 3 bolts.
Refit ..
CAUTION: Make sure that the wiring harness and the air suspension pipes are not trapped
behind the air suspension compressor bracket.
CAUTION: Make sure the air suspension compressor upper cover is correctly positioned.
NOTE:
Install the upper retaining bolt first.
Install the air suspension compressor.
Tighten the bolts to 10 Nm (7 lb.ft).
Connect the air lines.
Connect the electrical connectors.
Install the air suspension compressor lower cover.
Install the bolts and tighten to 9 Nm (7 lb.ft).
Using T4, pressurize the air suspension.
Start and run the engine.
Simple to swap ..but not sure of the T4 computer side ..
I would of thought simply by letting the air out of one of the pipes would do ..but im no expert. G4 Gone ...but not forgotten
|
| 25th Jan 2008 2:01 pm |
|
|
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14372
|
I have pics aswell ..if you pm me an email address i will send them ..
I have run out of gallery space otherwise would have posted aswell  G4 Gone ...but not forgotten
|
| 25th Jan 2008 2:06 pm |
|
|
